Electronics Forum | Sun Apr 18 14:26:36 EDT 1999 | Steve Gregory
| | Please visit our Web site, especially 'link page', to get some hint for roll typr of cleaning wiper for automatic screen printers. http://www.squeegee.co.kr | | | Idiot: I wouldn't visit your site if I had to start using toilet paper. Keep yo
Electronics Forum | Sun Apr 18 19:16:28 EDT 1999 | Wayne Bracy
| | | Please visit our Web site, especially 'link page', to get some hint for roll typr of cleaning wiper for automatic screen printers. http://www.squeegee.co.kr | | | | | Idiot: I wouldn't visit your site if I had to start using toilet paper. K
Electronics Forum | Sun Apr 18 19:18:28 EDT 1999 | Wayne Bracy
| | | | Please visit our Web site, especially 'link page', to get some hint for roll typr of cleaning wiper for automatic screen printers. http://www.squeegee.co.kr | | | | | | | Idiot: I wouldn't visit your site if I had to start using toilet pap
Electronics Forum | Wed May 03 13:34:04 EDT 2023 | proceng1
When we get a bad print at SMT, the operator uses the alcohol wipes and wipes the paste off the board. Then they use compressed air and another wipe. In most cases this is sufficient. Most vias are tented, but there still remains some solder sphere
Electronics Forum | Thu May 04 11:39:10 EDT 2023 | dontfeedphils
We typically wipe the boards with a lint free wipe soaked in the same under stencil cleaning solution we use in our printer, then run it through our spray-in-air stencil wash.
Electronics Forum | Thu May 04 19:13:56 EDT 2023 | proceng1
This isn't always an option. We do a lot of very fine pitch and often will get a clogged aperture and have to wipe and print again. Also, as we are CM, some of our boards are customer supplied and they do not send any "test" boards.
Electronics Forum | Thu May 04 11:37:25 EDT 2023 | proceng1
Thank you. I do feel that the document is very lacking in detail. It mostly says "yes, it needs cleaned. Make sure the cleaning process doesn't screw it up". The majority of boards that get wiped are already populated on the other side. So that lim
Electronics Forum | Thu May 04 19:43:49 EDT 2023 | auriga2001
The idea is you test printing cycles with one board before thoroughly cleaning it. The board doesn't get thrown away. You just test print and wipe one board until you get a good print, then thoroughly clean that board. What would you use to clean a p
Electronics Forum | Thu May 04 13:42:47 EDT 2023 | wippsen
there is no reason to completely clean a circuit board. If you don't use a professional cleaning machine, you will always have leftover paste. Use a test board until the paste print is ok. You can wipe this off several times until the paste print is
Electronics Forum | Fri May 05 15:41:54 EDT 2023 | proceng1
At the beginning, we absolutely do this with the first board. However, we do have some problem child jobs where we end up wiping 1 in 5 prints. When searching the topic, most of what I got was "ultra-sonic" cleaners, but that isn't recommended for
Main Products: 1. Original new and Original Used SMT/AI Spare Parts. 2. SMT Equipments And Related Machine( SMT Calibration, SMT Feeder Carts,Conveyer etc.) 3. Maintenace and Repair Service Pre-Sales Service Provide details ab
Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
Building A, Jiepeng Square, Fuyong
Shenzhen, 30 China
Phone: 0755-33578694
