Electronics Forum | Tue Dec 14 13:39:16 EST 1999 | KA
Hello Everyone! I have encountered a situation where I have surface mount components on the backside of the board and I need to wave all the through hole leads on the backside as well. Can this be done? I thought of the possibility of adhering the
Electronics Forum | Thu Jun 16 03:25:19 EDT 2022 | leaderway0
AI/SMT spare parts and SMT equipment vendors from China-Leaderway Industrial Co., Ltd. The main distribution brands are Fuji, Samsung, Juki, Yamaha, Universal, Panasonic, Siemens, and Sony. Our websites: http://www.leadersmt.com Contact us !!! Email
Electronics Forum | Fri Nov 08 18:36:31 EST 2002 | leeloo
Nowadays I have a problem, I am in chsrge of the section of smt in my company, have a normal process inside my department with a minimal level of mistakes, the problem happens when the material is liberated to the lines of production on happened for
Electronics Forum | Fri Dec 17 09:24:46 EST 1999 | Marty Wetzel
KA, Joshua makes a good point. A wave solder fixture will allow you to process your double-sided boards without having to add the epoxy step. The one time fixed cost of a fixture is quickly offset by the time that you save by not gluing your SMT.
Electronics Forum | Tue Dec 14 14:26:20 EST 1999 | John Thorup
Sure KA, it's done every day. Be sure that the components to be used on the bottom can take the maximum heat of the wave and the delta T of entering the wave. Depending how complex the bottom side is you will get better results with attention paid
Electronics Forum | Sat Nov 09 15:13:06 EST 2002 | mjabure
If I understand what you're saying, you are reaching reflow temp's on the top side while soldering bottom side components. You might want to run a glass gauge plate over the wave and make sure your contact pattern isn't too large. If your PCB is in c
Electronics Forum | Sat Nov 09 08:04:52 EST 2002 | erhard
if you wave solder you have to glue the SMD parts on the bottom side. If you reflow the bottom side then you usually shouln't go over the wave afterwards. It's quite logical the joints melt again, that's what you want to achieve going over the wave.
Electronics Forum | Wed Dec 15 04:59:40 EST 1999 | Joshua Hall
Hello KA, When producing in kind of PCB product you have to base much of your decision on cost effectiveness, time, and quality. In order to get the best of all three you have to decide which you want to be your top priority. By adding an epoxy to
Electronics Forum | Mon Nov 11 11:42:26 EST 2002 | MikeF
Like Mark, I'm guessing your problem is with SMT parts on the top side, the solder is re-melting and some of the parts are moving around during when the board is being wave soldered. When I had some training on thru hole wave soldering way back when
Electronics Forum | Fri Dec 17 03:38:53 EST 1999 | cklau
Hello Guys; I "ll like to add some comment on Mr John message , see below.. "Be sure that the components to be used on the bottom can take the maximum heat of the wave and the delta T of entering the wave."-John The required preheat temp , that i
DONGGUAN KINGSUN AUTOMATION TECHNOLOGY CO.,LTD is a company which mainly provide used and new SMT parts, provide repair SMT key parts service,new/used SMT machine trading,SMT consumables and Peripherals equipment,Clean room, ESD..
3th, Tangchang 3rd Road, Hengli, Dongguan City
Dongguan, 30 China
Phone: 8615629932323
