Electronics Forum | Wed Apr 13 21:47:32 EDT 2005 | Dhanish
In production,we are seeing high defect for Hair Line Solder Shorts for PTH connector and the Hair Line is too tiny that X-Ray and ICT could not detect.Any suggestion on how we can resolve or at least detect this upfront.
Electronics Forum | Thu Apr 14 11:03:51 EDT 2005 | patrickbruneel
All possible causes aside, how can a dead short pass your ICT unless the connector is not probed.
Electronics Forum | Fri Apr 15 09:10:09 EDT 2005 | Dhanish
The biggest problem I am having is the X-Ray and ICT could not detect this shorts.ICT could not detect because onboard measurement shows Zero even without the Hair line shorts.With Hairline there is no difference in the impedance value for ICT to fai
Electronics Forum | Tue Nov 13 09:17:47 EST 2001 | dxiong007
Hello All, I just got a project of removing 1800 Mictor connectors. Does anyone have experiences on removing AMP Mictor connectors? A Mictor connector has both SMT pins and PTH pins. Thanks for any suggestions. Have a nice day! Dennis
Electronics Forum | Wed Aug 24 22:53:34 EDT 2005 | mrduckmann2000
We have a customer that is using the new Hirose connector p/n df30fc-40dp-0.4v. The connector has lead spacing of .4mm. I beleive that if I have a stencil cut to 2-3 mil I should have enough solder paste to solder the connector to the PCB pads. Ho
Electronics Forum | Thu Apr 14 09:21:52 EDT 2005 | pr
What kind of wave are you using? Is this an old job and a new problem? Sounds like dross shorting to me, Make sure the wave is flowing over the back plate (at least when the board hits it). good luck, pr
Electronics Forum | Tue Feb 17 01:59:43 EST 2015 | vb7007
Travel Direction Similar Part : http://nz.rs-online.com/web/p/rj45-connectors/8208205/ And we are getting Solder short on every PCB and also additionally Dry joints (leads) on some. Played with Flux adjustments and also Parameter settings for wave,
Electronics Forum | Thu Apr 14 18:51:19 EDT 2005 | KEN
What side is the short occuring on. Topside or bottom (solder) side? 2. Pitch of hole pattern = ? 3. Your x-ray may not have the resolution or DSP capable of detecting this defect. How does your profile look? Is this a true short or the result
Electronics Forum | Mon Jul 06 06:45:47 EDT 1998 | Carlos Martinez de Guere�
I'm looking for a SMT connector for power electronics (25 Amps.). On solution is to use multi-contact (1Amps) connectors, but I'd prefer an one-contact one. Has anybody worked with a such device?
Electronics Forum | Thu Aug 07 15:12:41 EDT 2003 | barryg
We are planning on placing a smt connector, the spec sheet calls out that "suction tape is added for smt suction". I am assuming that since this is a straight connector and I will be picking it up across where the pins are (male connector)that there
Main Products: 1. Original new and Original Used SMT/AI Spare Parts. 2. SMT Equipments And Related Machine( SMT Calibration, SMT Feeder Carts,Conveyer etc.) 3. Maintenace and Repair Service Pre-Sales Service Provide details ab
Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
Building A, Jiepeng Square, Fuyong
Shenzhen, 30 China
Phone: 0755-33578694
winsouce.jpg)
.gif)
.png)