Electronics Forum | Thu Jul 20 19:51:40 EDT 2006 | darby
Are you trying to tie someone to an agreed wastage level or are you being tied? What machines are you talking about? What components are you talking about? The only acceptable wastage level is zero: but you can't get to zero until you've had some was
Electronics Forum | Thu Aug 09 09:05:09 EDT 2007 | davef
There are no requirements acceptance criteria for baking of board assemblies. What are your customer requirements? The common reasons people choose to bake PCB are to prevent: * Delamination of multilayer boards * Measles, particularly on double si
Electronics Forum | Mon Feb 22 12:20:51 EST 1999 | Dave F
| Does anybody have any reliable alternatives to device bake out for plastic bodied components. We do not use a whole package at time and therefore have to oven bake the balance before we can use them. | I have come accross dry nitrogen storage cham
Electronics Forum | Tue Aug 14 19:49:21 EDT 2007 | htran
My apology for not mentioned the J-STD-001DS. I didn't mean to trick you. Anyway thanks for your inputs. You are the man with the smt knowledge, I am sure that I will be asking you for some more answers again. Thank you for the link. I will loo
Electronics Forum | Wed Sep 23 13:44:57 EDT 2020 | emeto
Hello SMT bear, 1. Is the embossed tape the correct tape for the component? Sometimes packaging services might use wrong tape if part was sent for tape and reel. CAn you tell us what package the component is? What tape is it packaged in? 2. Feeders
Electronics Forum | Thu Nov 12 04:40:03 EST 1998 | Galen
| Scott - Good to see things are going well for you. With regard to your comments, Quad has introduced a complete line of Semi-conductor/APT machines (Q Series) that support both SMT and Semi-conductor applications. The machines were introduced in
Electronics Forum | Fri Feb 11 20:16:43 EST 2022 | mihai_voivod
Hi guys, This stubborn conveyor (inline smt 1m 2 stage) keeps popping off its track. I have tried to replace the old belt, turn the new belt around, tighten it as much as I can, but it keeps coming off the little wheels as shown in the picture. D
Electronics Forum | Thu Jul 12 11:56:20 EDT 2012 | hegemon
You might try to complete all your soldering within a 72 hour or less time frame. For all intents treat your board like a moisture sensitive component after you have baked and completed SMT reflow. Wash, blow dry, and go direct to stuffing and com
Electronics Forum | Mon Feb 06 18:45:26 EST 2023 | nitroone
Hi guys, So i am trying to find out what type of air quality sensor you use in your facility if any? What other sensors are required to be installed to ensure that air quality is safe for workers? We have both an inline oven, and a selective solde
Electronics Forum | Tue Feb 15 03:56:18 EST 2022 | cbeneat
Is the wheel that drives the belt in alignment? I assume all the bearings are turning. We've had bearings in the past be on the edge of seizing in our end pulley's. Tightening too much could cause it to turn harder, causing the belt to jump off. Coul
Main Products: 1. Original new and Original Used SMT/AI Spare Parts. 2. SMT Equipments And Related Machine( SMT Calibration, SMT Feeder Carts,Conveyer etc.) 3. Maintenace and Repair Service Pre-Sales Service Provide details ab
Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
Building A, Jiepeng Square, Fuyong
Shenzhen, 30 China
Phone: 0755-33578694