Electronics Forum | Wed Jul 14 19:15:59 EDT 1999 | JohnW
| Can plcc's be glue on the a board if not why? | Ron, The biggest problem you have with PLCC's is the hieght of the base of the component from the board, if you can get a glue dot high enough then yes you could do it. Probably the best method is d
Electronics Forum | Thu Sep 02 10:35:46 EDT 1999 | Gian.D
We are assembling double side pcs reflowing (smt) on top and by wave on bottom. After first step (smt) we dispense glue on the bottom side putting one or two glue dots under small components and we cure in oven before wave. After wave soldering we f
Electronics Forum | Thu Nov 17 13:51:27 EST 2005 | mnguyen
Never could get that thing to work rite. Better off getting a glue stencil or a manual dispenser. Even if you do get it to work it is difficult to control the glue dot size to stay stable either you get too much or not enough.
Electronics Forum | Thu Sep 02 14:42:52 EDT 1999 | JohnW
| We are assembling double side pcs reflowing (smt) on top and by wave on bottom. | After first step (smt) we dispense glue on the bottom side putting one or two glue dots under small components and we cure in oven before wave. | After wave solderin
Electronics Forum | Tue Sep 07 12:51:02 EDT 1999 | Brad Kendall
| | We are assembling double side pcs reflowing (smt) on top and by wave on bottom. | | After first step (smt) we dispense glue on the bottom side putting one or two glue dots under small components and we cure in oven before wave. | | After wave so
Electronics Forum | Mon Oct 02 11:23:04 EDT 2006 | ccapezza
EFD, Inc. manufactures adhesive dispensing equipment and may be able to offer assistance with your application. Check out our product information at http://www.efd-inc.com. We manufacture dispensing equipment ranging from manual dispensers to XYZ b
Electronics Forum | Tue Aug 04 11:10:22 EDT 1998 | Chrys
| Hi Stoney, | Justin is giving you some good advice, unfortunately these kinda' problems sometimes call for the ol' D.O.E...otherwise, you could be chasing your tail for a while until you figure out exactly what's causing your problems. | Has
Electronics Forum | Mon Nov 01 06:19:45 EST 1999 | Michael Fogel
I suggest tow more ways: 1. try to differ the temperaturte between top and bottom side duering the reflow process. 2. try to add some glue dots under the falling parts befor the placement/reflow process Good luck Michael
Electronics Forum | Mon Nov 01 06:27:15 EST 1999 | Michael Fogel
I suggest tow more ways: 1. try to differ the temperaturte between top and bottom side duering the reflow process. 2. try to add some glue dots under the falling parts befor the placement/reflow process Good luck Michael
Electronics Forum | Wed May 27 13:42:08 EDT 1998 | Chrys
| R&D is currently designing a board with smt components on both sides of the board. They are adding a 16 pin IC Gull wing. on the bottom side of the board. I have asked for only caps and resistors to be placed on the bottom side. Is there a recommen
Main Products: 1. Original new and Original Used SMT/AI Spare Parts. 2. SMT Equipments And Related Machine( SMT Calibration, SMT Feeder Carts,Conveyer etc.) 3. Maintenace and Repair Service Pre-Sales Service Provide details ab
Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
3 Road Xintang， Fuhai Street，Fuyong
Shenzhen, 30 China
Phone: 13713862102
