Electronics Forum | Mon Nov 27 20:44:01 EST 2017 | cmchoue
Dear expert's, I want to find the carrier that can support SMT print,placement,reflow and size can adjust. (My production is Motherboard) Does anyone have experience on it?or any infromation or photo can reference? Thanks Best w
Electronics Forum | Thu Nov 30 20:30:39 EST 2017 | cmchoue
Thanks Russfrom~It's useful infor.
Electronics Forum | Wed Dec 27 08:18:24 EST 2017 | sumote
I also recommend Pentagon EMS.
Electronics Forum | Thu Dec 07 11:21:56 EST 2017 | slthomas
It's been a while since I've dealt with them personally but I have worked with several guys that swear by Pentagon EMS for all of their fixturing. http://www.pentagon-ems.com/
Electronics Forum | Tue Nov 28 10:30:14 EST 2017 | georgetruitt
CHECK OUT INSULFAB OR STONE MOUNTAIN TOOL http://insulfabtools.com/gallery http://stonemountaintool.com/fixtures/
Electronics Forum | Wed Dec 06 07:24:22 EST 2006 | davef
Successful solder paste overprint is a function of the solder paste rheology, solder mask and through hole component stand off. * Solder mask with a high surface energy will permit a larger overprint than a solder mask with a lower surface energy. In
Electronics Forum | Wed Jun 03 13:50:32 EDT 1998 | Chrys
| Can anyone tell me if there is a reference for smt component height specs on the bottom side of a board, which will also go through wave soldering. A current design I am reviewing has tant caps(7343) and a crystal on the back side. Should I only b
Electronics Forum | Fri Nov 08 18:36:31 EST 2002 | leeloo
Nowadays I have a problem, I am in chsrge of the section of smt in my company, have a normal process inside my department with a minimal level of mistakes, the problem happens when the material is liberated to the lines of production on happened for
Electronics Forum | Fri Dec 17 03:38:53 EST 1999 | cklau
Hello Guys; I "ll like to add some comment on Mr John message , see below.. "Be sure that the components to be used on the bottom can take the maximum heat of the wave and the delta T of entering the wave."-John The required preheat temp , that i
Electronics Forum | Wed May 19 11:28:44 EDT 1999 | Martin Benites
Hi everyone. My name is Martin Benites from LIma, Peru. I am actually working on a project for automate PCB assembly process in our industry. Actual process is hand-based, thus our startpoint is zero equipment. I have already asked some companies fo
Main Products: 1. Original new and Original Used SMT/AI Spare Parts. 2. SMT Equipments And Related Machine( SMT Calibration, SMT Feeder Carts,Conveyer etc.) 3. Maintenace and Repair Service Pre-Sales Service Provide details ab
Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
3 Road Xintang， Fuhai Street，Fuyong
Shenzhen, 30 China
Phone: 13713862102
