Electronics Forum | Thu Nov 18 09:27:20 EST 2004 | vinod
Hi, Our company is specialized for design and we have in house assembly shop too. So we are one of the contract manufacturer. If you like we can send you information.
Electronics Forum | Wed Nov 17 09:51:25 EST 2004 | AS
I'm looking for advise on setting up a prototype station for smt (we are currently outsourcing smt production, but have a need for rapid in house prototyping). The station must be able to handle only single sided boards with components no smaller th
Electronics Forum | Wed Nov 17 15:04:27 EST 2004 | russ
SMT assembly, First, you must utilize paste otherwise the parts will not stay put. Do you have any leaded devices such as QFPs or SOICs? Dispensing paste by hand is very difficult and time consuming for these types of parts. You can either dispense
Electronics Forum | Wed May 13 16:43:31 EDT 1998 | PAUL OHAMA
Any ideas on what to buy? Only need to build surface mount protos, ability to rework. Is a rework station okay? Will subcontract production after design is proven.
Electronics Forum | Wed Apr 26 13:12:49 EDT 2000 | John Biskup
Can anyone give me a pointer to information about obtaining a prototype board for an SMT circuit. Thanks
Electronics Forum | Wed Apr 26 22:35:10 EDT 2000 | Dave F
John, try: APC Circuits 403.250.3406 bbs291.9342 Proto Express 408.735.7137 fax1408 Proto Engineering Sunnyvale, CA 408.738.0693 Glynn Shaw Advanced Circuits 21100 E 33Road Dr Aurora CO 80011 800.289.1724 www.4pcb.com
Electronics Forum | Wed Apr 26 22:34:49 EDT 2000 | Eric Chua
1. Verify all the part had load to machine. Get ready for the profile. 2. Run the board with double side tape. Is better to run one board for each machine. 3. Verify all the placement ( missing, misalgnment,etc )and check the value using meter for a
Electronics Forum | Thu May 14 09:01:11 EDT 1998 | Robert Murphy
| Any ideas on what to buy? Only need to build surface mount protos, ability to rework. Is a rework station okay? | Will subcontract production after design is proven.
Electronics Forum | Tue Jun 23 11:08:42 EDT 1998 | Russ Miculich
| Any ideas on what to buy? Only need to build surface mount protos, ability to rework. Is a rework station okay? | Will subcontract production after design is proven. Best bet is to get an Elite or OK Industries manual printer if you are not doing
Electronics Forum | Mon May 18 10:54:46 EDT 1998 | Jerry
If it's really low volume I would only invest in a stencil printer and convection reflow oven to start with. If you want to go really low budget get a manual unit such at one from Transition Automation. Make up some really good shop aids and have s
Main Products: 1. Original new and Original Used SMT/AI Spare Parts. 2. SMT Equipments And Related Machine( SMT Calibration, SMT Feeder Carts,Conveyer etc.) 3. Maintenace and Repair Service Pre-Sales Service Provide details ab
Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
Building A, Jiepeng Square, Fuyong
Shenzhen, 30 China
Phone: 0755-33578694
