Electronics Forum | Wed Mar 02 09:28:02 EST 2005 | bobsavenger
I am looking for images of solder paste defects like Past stringing, paste gorging and dog ears. I would also like to have the avi file to show how tombstoning happens in the reflow oven. Thanks Bob
Electronics Forum | Wed May 07 09:24:33 EDT 2003 | davef
Kris The majority of our tombstoning in very small passive SMT is caused by imperfections in end-cap solderability protection plating.
Electronics Forum | Fri Apr 25 08:48:25 EDT 2003 | davef
If what you say is accurate, two thing come to mind: * Pads on the board are incorrect for the tombstoning components. * Profile is different on the individual pads of tombstoning components. We have heard of, but never seen, components [tants] that
Electronics Forum | Thu May 01 17:49:33 EDT 2003 | jym2000
Did you check board orientation into the reflow oven? (The Layout components are the same products A & B?) Regards Jesus
Electronics Forum | Mon May 05 03:53:41 EDT 2003 | praveen
Do not 'ON" the nitrogen during reflow. If the pad of the chip is bigger then reduce the pad width from out side. Reduce the ramp rate at any point of the profile below 1 deg c/sec.
Electronics Forum | Mon May 05 03:53:47 EDT 2003 | praveen
Do not 'ON" the nitrogen during reflow. If the pad of the chip is bigger then reduce the pad width from out side. Reduce the ramp rate at any point of the profile below 1 deg c/sec.
Electronics Forum | Thu Apr 24 23:04:45 EDT 2003 | yukim
I've been struggling with this problem for a while. We have two products: A, which is Ok and B, with tombstone defect (0603 & 0805 capacitor chips). A & B have the same design: pad sizes, separation between pads, components orientation. Both have s
Electronics Forum | Wed May 07 09:02:17 EDT 2003 | Kris
Hi SnAg is a binary alloy and does not have the same effect as a ternary SnAgCu alloy as far the pasty range is concerned. But then paste only can do so much. The best way to do it is to have proper pad design, controlled placement and reflow. I w
Electronics Forum | Tue Jun 03 21:50:57 EDT 2003 | yukim
A question regarding the rampup slop: as we cannot make the preheat time long enough due to our reflow oven limits, a Loctite technician suggested we increase the rampup slope, between the initial point (25C) and 80C, to 4C/sec, as between these temp
Electronics Forum | Fri Sep 20 17:43:03 EDT 2019 | deanm
Looks like poor wetting/solderability to me. I don’t see heel fillets on the leads where the solder balls up. The solder has to go somewhere. It won’t flow where it won’t wet. Try printing a bare board and run through reflow. If the solder balls up o
Main Products: 1. Original new and Original Used SMT/AI Spare Parts. 2. SMT Equipments And Related Machine( SMT Calibration, SMT Feeder Carts,Conveyer etc.) 3. Maintenace and Repair Service Pre-Sales Service Provide details ab
Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
Building A, Jiepeng Square, Fuyong
Shenzhen, 30 China
Phone: 0755-33578694
