Electronics Forum | Wed Oct 30 15:50:22 EDT 2013 | joeherz
Vince, We see the same disks on some parts incoming. SMT PEM nuts in tape and reel are very common. We get the parts from PENN Engineering. One of them is SMTSO-M3-4ET. PENN Engineering may be able to steer you in the right direction on who their
Electronics Forum | Fri Oct 13 19:01:46 EDT 2023 | crystalw4280
I have an old Juki 2060 The electors were replaced on some heads that were disabled. Now we are showing some of the same errors with those heads. Does anyone have any suggestions for possible cause that would make this happen again. Another warning
Electronics Forum | Tue Oct 24 19:09:12 EDT 2023 | sarason
Possibly blocked air lines did you check air pressure? Also drivers on the relevant boards. or simply damage in the flexible wiring harness( a nightmare) sarason
Electronics Forum | Mon Jan 10 19:13:46 EST 2000 | TNT
HELLO MIKE, THE PROBLEM WITH THE VIA BEING IN THE MIDDLE OF THE PAD CAN BE HANDLED. IF YOU ARE HAVING PROBLEMS WITH SOLDER FLOWING THROUGH AT REFLOW YOU MIGHT WANT TO CHECK YOUR VACUUM AT YOU SCREEN PRINTER. SOMETIMES THE VACUUM THAT HOLDS THE PCB
Electronics Forum | Thu Dec 10 13:27:36 EST 1998 | Dave F
| Dear everybody : | Does anyone have some information about "bleeder pad"? it seems a method to avoid solder shorts across very small SMT pads.If someone have any idea about it, please contact with me , thanks ! | Young: I'm unfamiliar with the
Electronics Forum | Wed Dec 09 18:56:40 EST 1998 | young
Dear everybody : Does anyone have some information about "bleeder pad"? it seems a method to avoid solder shorts across very small SMT pads.If someone have any idea about it, please contact with me , thanks !
Electronics Forum | Sun Aug 26 11:27:12 EDT 2007 | vangogh
Hi Davef, Thanks for the reply. There seem to be no issues on SMT reflow based on some samples done. We have not stripped the gold yet. We did a X-section+EDX and we are seeing traces of copper on the nickel layer. Any idea what is the implication of
Electronics Forum | Fri Nov 17 15:04:59 EST 2006 | ehess
WE have a problem with a DPAK component floating during reflow, causing it to move to the point where it affects the toe fillet. We have been using a dot of SMT epoxy to hold it secure for the moment. I have looked on many sites, but no whrere can
Electronics Forum | Thu Jun 16 18:16:32 EDT 2005 | davef
Josh: You're correct it's tough to describe the layout of the BGA pads and traces. We wouldn't be too excited about seeing this board either. On one hand, for the obvious lack of care taken in doing the layout, this is a junk board and you shouldn
Electronics Forum | Sat May 30 01:31:49 EDT 2009 | mika
make 4 square rounded corner apertures on the ground pad and the total reduction of 20 % (80 % solder paste). Then you still be able to solder the terminals around. Don't worry to much of the void's. Just following my tips and you will be fine. The
Main Products: 1. Original new and Original Used SMT/AI Spare Parts. 2. SMT Equipments And Related Machine( SMT Calibration, SMT Feeder Carts,Conveyer etc.) 3. Maintenace and Repair Service Pre-Sales Service Provide details ab
Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
Building A, Jiepeng Square, Fuyong
Shenzhen, 30 China
Phone: 0755-33578694