Electronics Forum | Mon Jan 13 18:22:55 EST 2003 | davef
100 sec) and decrease reflow temp to 205C. * Understand that voids are primarily process indicators. There is experimental evidence that voids retard crack propagation locally around the void on a temporary basis. There is no standard, IPC or otherw
Electronics Forum | Thu Mar 01 11:43:08 EST 2001 | dason_c
Not enough info, when you say no clean flux, is it for wave soldering process, please provide more detail, SMT or wave, is it all the joint which you find the void? Rgds
Electronics Forum | Tue Mar 06 03:29:05 EST 2001 | daled
Hello I am looking for any data that confirms the long term reliabilty of no clean paste as opposed to water soluable. Does anyone have any past experiences of problems when changing over from water soluable to no clean in the SMT prcocess?? Thanks i
Electronics Forum | Sat Mar 27 08:15:02 EST 2004 | davef
Via in pad is a designer's dream and an assembler's nightmare. Search the fine SMTnet Archives for previous discussions to get started. VIP, via-in-pad, or whatever tend to promote voiding within the via and certainly partially starved solder conne
Electronics Forum | Thu Jun 28 17:05:46 EDT 2012 | davef
Here’s what we seem to know: * There’s a problem with voiding in the solder connections of SMT capacitors * A void is an open area caused by air or process fluid that is trapped within a solder connection * Voids are an allowable condition as long as
Electronics Forum | Thu Apr 01 10:05:32 EDT 2010 | brandenspencer10
Hi, My name is Branden Spencer and I am a jr. engineer at TTM technologies. We are currently having and issue with our wave solder process. We are getting what looks like either solder dross or voiding in our solder joints (through hole and SMT). We
Electronics Forum | Wed Jun 27 21:56:31 EDT 2012 | davef
I'm spinning on this. Are we talking PTH or SMT?
Electronics Forum | Thu Apr 01 14:43:26 EDT 2010 | cbart
You say its in both smt and through hole, but, are you waving the SMT parts as well, I assume yes since you think its dross in the joints. Questions: 1- do you have higher mag scopes that you can zoom in a little more to see if these are voids or dr
Electronics Forum | Thu Jun 28 09:43:25 EDT 2012 | ssupertuba
I'm sorry. These are SMT caps such as a C0805C271J1GAC. Small 0805 caps. I know they gennerally give you solder balls that sit on the side of those parts but they wash off.
Electronics Forum | Mon May 06 11:45:32 EDT 2019 | slthomas
There are quite a few papers out there on the subject. Just enter "SMT void reduction" into google or other search engine and take your pick. That said, slow ramp rates and paste volume reduction are a good place to start. Although I haven't tried i
Main Products: 1. Original new and Original Used SMT/AI Spare Parts. 2. SMT Equipments And Related Machine( SMT Calibration, SMT Feeder Carts,Conveyer etc.) 3. Maintenace and Repair Service Pre-Sales Service Provide details ab
Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
Building A, Jiepeng Square, Fuyong
Shenzhen, 30 China
Phone: 0755-33578694
