Electronics Forum | Fri Apr 13 19:38:28 EDT 2001 | Mike R.
I'm in Anaheim Area, if any body needs help for SMT Carrier Plate, Print Plate, Solder wave jig/Pallet and Assembly jig, Please send me an e-mail. miker228@cs.com
Electronics Forum | Fri Nov 08 18:36:31 EST 2002 | leeloo
Nowadays I have a problem, I am in chsrge of the section of smt in my company, have a normal process inside my department with a minimal level of mistakes, the problem happens when the material is liberated to the lines of production on happened for
Electronics Forum | Fri Dec 17 09:24:46 EST 1999 | Marty Wetzel
KA, Joshua makes a good point. A wave solder fixture will allow you to process your double-sided boards without having to add the epoxy step. The one time fixed cost of a fixture is quickly offset by the time that you save by not gluing your SMT.
Electronics Forum | Tue May 17 09:58:42 EDT 2005 | Fred N
Thx to everyone who replied. we will be running single sided thru hole and double sided smt, 186 rosin flux cause they tell me it can take the heat needed for 18 layer pwbs. some long leads. also they are ordering in pallets to deal with the irregu
Electronics Forum | Thu May 07 13:22:37 EDT 1998 | Chrys
| I am running a board that is .062" thick and has components that over hang the edge of the board by .090". I have bottom side smt components (chip caps and resistors only) and use the turbulent wave to help solder the components. The problem I am
Electronics Forum | Thu May 07 12:54:01 EDT 1998 | DARRYL SCHLOSSER
| I am running a board that is .062" thick and has components that over hang the edge of the board by .090". I have bottom side smt components (chip caps and resistors only) and use the turbulent wave to help solder the components. The problem I am
Electronics Forum | Thu May 07 12:29:17 EDT 1998 | Rob Williams
I am running a board that is .062" thick and has components that over hang the edge of the board by .090". I have bottom side smt components (chip caps and resistors only) and use the turbulent wave to help solder the components. The problem I am h
Electronics Forum | Mon Apr 01 19:57:07 EST 2002 | davef
Selective soldering machines are a good way to "finish automation", if the design of the PCB is conducive to the application with just a few components to solder. Your points are good. A decision matrix for selecting a machine might also include:
Electronics Forum | Fri May 08 08:12:32 EDT 1998 | Steve Gregory
| I am running a board that is .062" thick and has components that over hang the edge of the board by .090". I have bottom side smt components (chip caps and resistors only) and use the turbulent wave to help solder the components. The problem I am
Electronics Forum | Thu May 07 21:25:56 EDT 1998 | D.Lange
| I am running a board that is .062" thick and has components that over hang the edge of the board by .090". I have bottom side smt components (chip caps and resistors only) and use the turbulent wave to help solder the components. The problem I am
Main Products: 1. Original new and Original Used SMT/AI Spare Parts. 2. SMT Equipments And Related Machine( SMT Calibration, SMT Feeder Carts,Conveyer etc.) 3. Maintenace and Repair Service Pre-Sales Service Provide details ab
Manufacturer's Representative / Manufacturer / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
3 Road Xintang， Fuhai Street，Fuyong
Shenzhen, 30 China
Phone: 13713862102
winsouce.jpg)
