Electronics Forum | Thu Mar 10 14:31:57 EST 2005 | russ
Patrick told you why, But here is some more info for ya, I would absolutely not recommend that wires be tinned with OA. The residue will never get cleaned underneath the insulation and all of your strands will strt to break in the near/far future.
Electronics Forum | Thu Mar 10 13:05:41 EST 2005 | patrickbruneel
This phenomenon is caused by a high amount of halogens (Cl, Br etc.) used in the flux activators or in the flux surfactants. We've seen effects creating all colors of the rainbow. Changing to No-Clean (halide-free) will eliminate this color effect.
Electronics Forum | Thu Mar 10 15:43:06 EST 2005 | steve
Thank you both for your assistance. I knew that I could count on you folks. The customer has purchased No-Clean flux and is using it as we speak. Hows that for customer service.... All in a days work... Thanks again You make me look good!!! Steve
Electronics Forum | Mon Jun 19 17:00:39 EDT 2006 | a_laser
The most common rates of in-process cleaning (under wipe) I have encountered are once per 5 to 10 prints. But this depends a on a lot of variables. More often is typically better, but more costly in under-wipe materials. (For some more info see http:
Electronics Forum | Wed May 24 04:28:18 EDT 2006 | ge_lim
Hi Anyone use Warton Active '8' flux to clean the nozzle? Share me your experience
Electronics Forum | Mon Aug 11 05:26:55 EDT 2008 | gersla
Hi All We are looking for not expensive solution for misprint PCB cleaning for both one and double side assemblies. We have tried different ways and cleaning solutions like: IPA, Vigon Zestron SD300, Vigon SC200 by deep the boards in to stainless ste
Electronics Forum | Wed Sep 25 15:58:36 EDT 2002 | bschreiber
Hello Dave, I hope that electronic slap didn�t hurt too much. Robf, I am sorry that you did not agree with my initial response, but the answer is very detailed and most of the support material I have is only in paper format so I need to either snai
Electronics Forum | Thu Sep 26 14:03:55 EDT 2002 | Randy V
There are allot of issue to washing that need to be considered before you purchase a washer. But to answer your question regarding ultrasonic cleaning: 1. Ultrasonics with the correct frequency will not damage most components. Washing in general can
Electronics Forum | Mon May 14 10:05:12 EDT 2007 | d0min0
hi, i'd like to know how do you maintain cleaness of your solder frames after production - we use both SnPb and leadfree process, we clean in alcohol and ultrasonic but the frames look white and i wonder if we do not damage the structure??? best re
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
.gif)
.gif)
