Electronics Forum | Thu May 18 16:27:53 EDT 2006 | bman
I don't have any experinence with this, but my concern is that you are limiting the amount of contamination your pot can absorb before you ever run a board through. What I mean is that even if you are able to drain all but about a kg of the old sold
Electronics Forum | Thu May 13 09:47:32 EDT 2004 | Lubo
We are looking for a inspection system to check the positioning of a component over a PCB. We need it positioned both in X Y directions and height above PCB (it is a TH component) to be within certain limits. PLS advise can this be achived by AOI. Wh
Electronics Forum | Mon Jan 29 11:14:44 EST 2001 | medernach
Hi all, Here's the deal. I have a customer for whom I assemble a lot of product. All of their product mix goes through a water soluble process. Much of it gets conformal coated. They are in the high power arena but some products are simply contro
Electronics Forum | Fri Feb 19 11:13:02 EST 2016 | ttheis
I'm setting up a product for the first time on my GSM after I completed debugging some other issues. The previous owners had the PWC axis disabled and the axis motor disconnected, so I re-connected it and enabled it and now it homes and moves. When I
Electronics Forum | Fri Oct 28 14:09:39 EDT 2022 | ttheis
Allowing a part to go over the board boundaries can cause collisions when boards are nested. The software on these machines has limitations but it is plenty capable and rooted in preventing physical damage to the machine. Once you are familiar with t
Electronics Forum | Tue Feb 09 09:18:13 EST 2010 | davemacnemo
Machine installer gave me some tips and a run through the software. Everything worked just fine. First solo attempt to run product that we started with gives L305 SoftLimitOver... error after picking first components and passing over camera. Additio
Electronics Forum | Wed Oct 31 03:35:41 EDT 2007 | meritajs
Hello All, We have problem with one from our YAMAHA SMT mounter. It had weard defect. It gives error message"soft limit X over" when next step must pick up with head3. But all coordinat for next component do not exeed movable range. This failure happ
Electronics Forum | Tue Sep 26 10:22:51 EDT 2006 | SWAG
Histogram: Place standard tooling block in centernest. Jog camera over block. Jog z-axis to soft limit. Place a white card under camera. User mode to test. Turn board lamp on. From test menu, select histogram. With board lamp on and white under camer
Electronics Forum | Wed Jun 05 13:01:26 EDT 2002 | Hussman69
Sure do. Spent a couple months with that group last winter trying to get the Soft Beam to solder a small connector board. It really depends on what you are trying to solder. The Soft Beam couldn't handle my job because our board was too small. No
Electronics Forum | Thu Nov 01 17:24:20 EDT 2007 | jmelson
I think the Yamaha 84S is very similar to my Philips CSM84. head 3 cannot reach all the feeder locations. I believe feeder locations 1-3 on the front rail, and is it 41-43 on the back rail (the first 3 again) are out of range for the X axis to move
