Electronics Forum | Fri Mar 17 14:59:50 EDT 2023 | proceng1
OK, does your axis screw have the flex coupler or the magnetic coupler? Which axis is it? Did you turn off soft limits? If it's out of range, soft limits won't let it move by controls. I need to know which axis before I can get too far into this. I
Electronics Forum | Mon Jan 08 19:52:14 EST 2007 | fastek
A soft limit error is an error due to trying to drive the head outside it's mechanical limits. Check your X-axis program data for this part.
Electronics Forum | Fri Jan 21 00:11:50 EST 2011 | jeffr
Yes you must select FixedTrayFeeder. You must select TEACHING not AUTOSET. The trap is... you must select a TEACHING UNIT prior to doing the teaching (CAMERA-HEAD1-HEAD2)are the choices. Press F8 to get this menu to appear. If the camera cannot reac
Electronics Forum | Tue Feb 09 12:15:14 EST 2010 | rajtaware
Check if the feeder position is out of picking area mentioned in manual. Change the feeder position.
Electronics Forum | Tue Feb 09 13:27:05 EST 2010 | duchoang
Re-optimize the program. One (or more) head(s) can not reach and pick up parts from certain feeders.
Electronics Forum | Mon Oct 25 21:28:38 EDT 1999 | Dave F
3%) concentrations of gold form brittle intermetallic compounds with the tin in your solder. Electroless gold is applied with an autocatalytic process that self-limits around 5 mils thickness. You're correct electrolytic gold is used for goldfinger
Electronics Forum | Tue Oct 15 10:46:47 EDT 2002 | Dan Davis
I have a supplier that utilizes a soft beam solder process for through hole components. We are experiencing bridging and cold joints on components with narrow pitch between pins. They are dragging the solder over these pins as well. I have asked f
Electronics Forum | Mon Oct 03 12:22:54 EDT 2005 | Stew
Depending on your application, you may need to pre-heat before Soft Beam (unless they make one for it now). Plus, very small connections seem to push it's limits. The beam can only get so narrow. Lasers are good but reflectivity can come into play
Electronics Forum | Fri Jun 04 09:20:55 EDT 1999 | HST-SE
Al, We make stencils, and I was personally involved at AMTX when the electroformed process was developed. Some of this will sound like an ad, but everyone has been volunteering vendors and so look at this as a suggestion. Electroforming is an addit
Electronics Forum | Mon Jan 08 01:47:35 EST 2007 | fpcb
hi to all, I have a old MPA-80 machine. I use it for simple boards without problems till now. For a more difficult board I have tried to use command "M801", I think that I have done everything right but I receive a error-message like " x(-)soft