Electronics Forum | Fri Feb 19 11:17:29 EST 2010 | kpm135
When I try to load a board in our MPM UP2000 HiE I get the following error "Z axis software limit". The Z axis will move up and down freely, I re-calibrated it and reprogrammed the board and the error continues. Has anyone else run into this issue an
Electronics Forum | Mon Feb 22 10:19:57 EST 2010 | swag
Check/reseat all connections on axis driver card and from driver card to step motor. On older MpM's it is common to get a bad connection on the connector for axis driver power and blow components on your driver board. Reseating these connectors mig
Electronics Forum | Thu Aug 06 11:41:10 EDT 2009 | swag
Is the aperture pattern on your stencil centered in the Y?
Electronics Forum | Wed Aug 05 14:20:21 EDT 2009 | jorge_quijano
Hello there, I'm having some problems w/MPM up2000, Vision Y axis software limit error, when I tried to create a new program, appears the "Value out of range for VY BSS POS, spec 0.00 min -26.5, read 8.45" message. Any idea of how to correct this pro
Electronics Forum | Thu Aug 06 12:46:15 EDT 2009 | jorge_quijano
Yes, it is centered, in fact is the same product we run everyday, problem shows up after maintenance was performed.
Electronics Forum | Thu Aug 06 13:54:13 EDT 2009 | lockj69w
We have this problem typically after a PM is performed and it is usually due to too much grease on the linear guide.
Electronics Forum | Fri Jul 29 02:50:18 EDT 2016 | pavel_murtishev
Hello, Could you please tell me what the latest Siemens F5HM software version is? Installed version we have is 407.03. It seems this software version does not support placement force adjustment for pick&place head that might be a critical point for
Electronics Forum | Mon Oct 28 08:27:53 EDT 2013 | emeto
There are many profilers(physical devices) on the market. Most of them have software that makes predictions based on information about the paste, oven model...., but I wouldn't trust the predictor as on your boards you will have different parameters
Electronics Forum | Sun Mar 22 19:11:43 EDT 2020 | sarason
THe Ealead software pretty much does everything for $1000US, Its big weakness is its importing, for this you use PCBSynergy. Have you tried the Ealead demo it run's for a month.But it is limited to 10 feeders sarason.
Electronics Forum | Fri Mar 20 11:14:02 EDT 2020 | kylehunter
I have, but it's super limited in comparison to being a full offline programmer. Especially with part sizes and nozzles