Electronics Forum | Thu Sep 04 02:43:09 EDT 2008 | benefon
Thanks This error only occurred with one oven profile with the reflow zone temperature set at 270�C. Perhaps it really has to do with the exhaust pull as the oven is operating very near its temperature limit with this profile. I will check that. Tha
Electronics Forum | Tue Sep 02 13:35:29 EDT 2008 | evtimov
Hi, I don;t thing there is an overtemperrature sensor. Just the thermocpouple returns a higher temp(voltage) to the controller and your software goes to alarm, cooldown or what ever it does. Emil
Electronics Forum | Fri Feb 19 11:17:29 EST 2010 | kpm135
When I try to load a board in our MPM UP2000 HiE I get the following error "Z axis software limit". The Z axis will move up and down freely, I re-calibrated it and reprogrammed the board and the error continues. Has anyone else run into this issue an
Electronics Forum | Mon Feb 22 10:19:57 EST 2010 | swag
Check/reseat all connections on axis driver card and from driver card to step motor. On older MpM's it is common to get a bad connection on the connector for axis driver power and blow components on your driver board. Reseating these connectors mig
Electronics Forum | Thu Aug 06 11:41:10 EDT 2009 | swag
Is the aperture pattern on your stencil centered in the Y?
Electronics Forum | Wed Aug 05 14:20:21 EDT 2009 | jorge_quijano
Hello there, I'm having some problems w/MPM up2000, Vision Y axis software limit error, when I tried to create a new program, appears the "Value out of range for VY BSS POS, spec 0.00 min -26.5, read 8.45" message. Any idea of how to correct this pro
Electronics Forum | Thu Aug 06 12:46:15 EDT 2009 | jorge_quijano
Yes, it is centered, in fact is the same product we run everyday, problem shows up after maintenance was performed.
Electronics Forum | Thu Aug 06 13:54:13 EDT 2009 | lockj69w
We have this problem typically after a PM is performed and it is usually due to too much grease on the linear guide.
Electronics Forum | Fri Sep 24 06:17:47 EDT 2010 | bullyparade
Hi all, we use a MPM UP2000/B printer and facing the following problem: During startup/initialisation process the printer stops after a while and comes up with the following alarm "hardware limit warning". This can be repeated several times with the
Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze
Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d
.png)