Electronics Forum | Thu Nov 15 03:13:08 EST 2007 | duyhoang
Dear all, I want to use fuji flexa software to connect to FIP2 (ROM version 1.82). Does anyone help me to connect it? Do I have to upgrade version of FIP2? Which steps do I have to do to use flexa for FIP2? If it needs to upgrade a higher ROm versio
Electronics Forum | Thu Oct 14 10:50:51 EDT 1999 | Tony
Carl, The software is available from Fuji America as well. To determine the kit you will require for the upgrade, you need to know what size hard drive you have in your system and then visit the FAC web page for a part number and pricing. http://w
Electronics Forum | Tue Oct 12 20:19:38 EDT 1999 | Eric Chua
| Hi All; | | I have heard there is a software to make MCS16F Y2K-OK. Has anyone heard if this is correct? If so, from where and how much? | | Thanks for your time; | Hi Carl, Yes, is correct. There is software for the MCS16f Y2K. I had
Electronics Forum | Tue Oct 12 20:22:04 EDT 1999 | Eric
| | Hi All; | | | | I have heard there is a software to make MCS16F Y2K-OK. Has anyone heard if this is correct? If so, from where and how much? | | | | Thanks for your time; | | | | | Hi Carl, | | Yes, is correct. There is software for t
Electronics Forum | Thu Oct 14 13:50:16 EDT 1999 | stefano bolleri
Eric, how does the upgrade work? Have you actually tested it after installation? Which tests have you performed? There are standard Y2K test programs currently being used, e.g. I have seen a "7-critical-dates" checklist which details shutdown-rollov
Electronics Forum | Tue Feb 05 15:01:50 EST 2013 | ercdave1
Thank you for the help and great advise. as of right now I am looking at a 2002 universal GSM2. its running UPS software Level 4.5 Supplement E, and it has updated heads. the machine is sold by PFI of florida. they will install, calibrate on site
Electronics Forum | Wed Sep 30 13:09:12 EDT 2015 | ercdave1
Hello Rob, I was able to get the machine to zero, apparently replacing the circuit board on head 2 conflicted with head one even matching the jumper settings to the old board. Once I marked the head as not mounted, head 1 zeroed. I re-checked the ju
Electronics Forum | Thu Sep 02 17:39:21 EDT 2004 | rcanten
I am looking for some help in upgrading my pc that I run PPU software on for my Universal AI equipment. I have installed PPU on a 840mhz pc and everything works fine except I can not transfer programs from the pc to the uicp. The error I get is buffe
Electronics Forum | Tue Jan 16 15:13:51 EST 2018 | ilavu
Hello All, I am in need for "Platform Set-up Validation" (PSV) for my Universal GSM2 with UPS version 4.5. My installation disk for PSV is bad and can not reinstall after hard drive crash.My machine is not register with Universal because some serial
Electronics Forum | Thu Aug 08 11:58:25 EDT 2013 | rway
I am not that familiar with the older systems. The software should be supported on both old and new alike unless you are limited by the operating system, but the camera will obviously have a lower resolution and perhaps the filtering is not quite as
.gif)
.gif)
