Electronics Forum | Tue Sep 09 07:03:56 EDT 2008 | mun4o
Hi All, we poduce diferent kind of Keyboards, and use a lot of SMT LEDs.When I looking for reflow soldering Conditions i n the Data Sheets, usually I find "IR-reflow" Soldering profile.Our Reflow owen have onli conventional heating.Is that problem?
Electronics Forum | Thu Feb 28 07:57:52 EST 2002 | caldon
Marcos- BGA's and soldering manually is difficult. Typically soldering BGAs requires reflow just as a reflow oven does, so I recommend a rework station. Go to http://www.empf.org/html/empfset.htm and download Jan 2002, Dec 2001, Sep 2001, Aug 2001,
Electronics Forum | Mon Oct 20 21:26:57 EDT 2014 | richardciccarone
I have seen a couple of references to Black Tar, Not Black Pad. Apparently, it occurs only on the solder side of PTH's after wave solder and primarily on the edges of the land. It is characterized by a black coloration (Not Ni corrosion?) and non-wet
Electronics Forum | Fri Jul 16 10:55:54 EDT 1999 | Jeff Ferry
We have been asked to rework several thousand bare circuit boards. A design change now requires 2 chip components where 1 was originally required. Round test pads near this area will be used to complete this circuit rework, however these test pads a
Electronics Forum | Wed Sep 08 17:28:11 EDT 1999 | Earl Moon
| | Has anybody have any experience with Top placement of BGA's. GLue descretes on bottom and then wavesolder.? | | | | | | | Hi Chris, | Why don't you process a double side reflow and use selective wave fixture for wave process. The process w
Electronics Forum | Wed Jun 24 14:20:53 EDT 1998 | Ben Salisbury
I know this topic has probably been talked about before...But I ran into a small situation where Solder Balls were appearing in large quantities on the PCB....the Problem has been isolated and taken care of, my question is, what are some good methods
Electronics Forum | Thu Oct 03 04:04:10 EDT 2002 | Bob Willis
SMTNet has a video tape and interactive CD ROM on Intrusive Reflow Soldering that you may want to check out. In addition there are some free inspection standards for pin in hole printing, placement and soldering available at http://www.dpmo-monitori
Electronics Forum | Wed Dec 18 08:19:00 EST 2002 | cyber_wolf
One thing that will also cause this is very slight stencil mis-alignment. Sometimes the paste will have a tendency to hang up in the apertures if you are over hanging just a little on the solder mask. Some solder mask are very slick and will not pull
Electronics Forum | Wed May 25 17:29:58 EDT 2005 | Peter
We are evaluating a low halide Water soldering flux (Aim WS716). Has anyone had good/bad experience with it? Our operator has mentioned strong and irrating smell, even when standing a foot away from the conveyor entry/exit. The fluxer is embedded w
Electronics Forum | Thu Aug 25 08:26:48 EDT 2005 | DannyJ
Hi MM, Off the cuff, is it possible that the QFP leads were not coated? I'm by no means an expert in QFP manufacturing, but I do believe that there is a coating which enables solderability that is added to the leads somewhere in the process. I ha
