Electronics Forum | Tue Sep 07 15:28:13 EDT 1999 | Earl Moon
Listed below are the issues Viking has been experiencing since the installation of the Proflow Head: 1. After installing new 350mm Wiper foil with metal strip glued on it, It worked for about a week and suddenly metal stri
Electronics Forum | Tue Oct 12 04:26:30 EDT 1999 | Brian
| We have three buckets filled with leftover solder paste from our screen printing process. Kester has informed me that they no longer take paste, but only dross and pot dumpings. Does anyone know if there's someplace I can recycle this, or am I go
Electronics Forum | Thu Sep 16 05:37:18 EDT 1999 | Earl Moon
| Can you imagine that there is a smt process using the a few chip and ic are nearly about 4,5,6,8 years old. | Antigues?? | what should you do If you are an engineer of smt process in that company. | | | | thank in advance. | | I'm s
Electronics Forum | Mon Aug 10 13:36:33 EDT 1998 | Mike Moninger
| | I am trying to get an idea of what system seems to work best for solder paste inspection. I am looking for basic table top models with he capabilites of height and width measurements. Can anyone give me suggestions, pricing and why you prefer
Electronics Forum | Tue Nov 27 10:16:07 EST 2001 | davef
Oooo, I get it. We do that trick on the wave solder side of boards. On the bare board, during design / layout, the basic shape of the jumper is a 125 thou disc of copper [that of course is eventually covered with whatever solderability preservative
Electronics Forum | Mon Jan 26 03:45:37 EST 2004 | Vinny
Hi All, We are producing a veriety of RF related PCBAs in which we see Unsolder/Mislaigned on a regular basis. In these baords usually one of the pad is connected to a signal trace and the other pad is connected to very huge ground plane. This gro
Electronics Forum | Thu Sep 23 11:56:30 EDT 2004 | rkevin
We are printing on an assembly using SAC305 Alloy Sn96.5 Ag 3 Cu .5 with a no clean flux and getting virtually NO spread with either a ramp to spike or straight ramp profile. We are printing to standard FR4 board with immersion Ag finish. I am trying
Electronics Forum | Mon Mar 15 09:38:30 EST 1999 | Chrys
| Does anyone have any recommendations on spray fluxers? Are there major differences between the high priced ultrasonic machines to the low priced flux/air spraying machines? We are going to be spraying an OA flux with 11% solids content. Are there a
Electronics Forum | Fri May 14 12:13:35 EDT 1999 | Heather
| Hi Guys, | | I am going to be graced with the good luck of processing microBGA's in the near future. A bit of a step forward from printing 20-mil pitch and wave soldering 0805's, wouldn't you say? | | So, any of you folks who have already experi
Electronics Forum | Sat May 22 19:38:59 EDT 1999 | Omat Marasigan
| Earl, | | your colourful impressive descrptions are a joy to read..well lighten's up my day but maybe it's just me...ummmm..? | | anyhoo, Omat, as Earl has said ..this is a moisture sensative problem basically the reason you blow the shit out of