Electronics Forum | Thu Nov 14 09:02:46 EST 2002 | MA/NY DDave
Hi Making contact has been one reported problem, so some testers put in higher force probes that then might cause problems. If fixturing is done correctly, the OSP is done correctly, and test follows close in time after soldering little problems s
Electronics Forum | Thu Nov 14 09:24:07 EST 2002 | joconnell
What about when debugging the board I recently saw a case where we damaged a board between - 5-10 cycles of the fixture It's a catch 22 - where you need high force probes to breal the OSP - but the copper is hard surface, not like the solder HASL a
Electronics Forum | Fri Nov 15 15:02:37 EST 2002 | MA/NY DDave
OK I know it is funny to have two different PWB/PCB processes, one for pre production and one post production yet it is possible if controlled and implemented in a strategy. In debug if your company's experience has been for a repeated need to do IC
Electronics Forum | Sun Dec 15 22:31:43 EST 2002 | craigj
Has anyone heard of vias cracking (barrel from pad) when being wave soldered. Was told this was a big problem by contract pcb designer, he always tent vias because of this. The reason was that the solder filling the vias caused stressing and then sep
Electronics Forum | Mon Dec 16 09:36:54 EST 2002 | russ
I have never had this problem. It sounds like you are right in imagining that there must have been a bad supplier of PCBS or an inadequate design rule being followed, or a very bad wave process to have this cracking over wave solder. Some books requ
Electronics Forum | Fri May 28 13:19:31 EDT 2021 | cbart
I can't see the image very well, but from what i see it looks like oxidation. looks like an ENIG finish on the board, possibly a plating issue from the bare board house, thin gold or the nickle is to thick. one other question i would get an answer t
Electronics Forum | Thu Jun 03 18:51:25 EDT 2021 | emeto
It seems like some oxidation that flux is able to fix on the soldered pads. Is it looking like this before you reflow?
Electronics Forum | Mon Dec 16 10:54:48 EST 2002 | davef
Knee of barrel and pad crack: Caused by thermal stress during soldering, because epoxy expands in the "z" 3X more than "x" or "y" which are restricted by the fiber. Related to: * Design of pads too large relative to hole diameter * Temperature at o
Electronics Forum | Tue Feb 23 08:46:11 EST 2021 | dianau
Hello, I have a topic with vias discoloration(that's what supplier said) and I don't know if it's an corrosion problem or something else. I believe that maybe the PCB's are not storage properly. I must mention that aren't any problem at soldering. D
Electronics Forum | Thu Nov 14 05:45:51 EST 2002 | Jon O'Connell
Has anyone had experiences of ICT test fixtures actually damaging the PCB boards - typically when they have moved away from HASL finish to OSP. I would also like to hear more about any specific issues seen at ICT for non HASL pcb finishes thanks -
.gif)
