Electronics Forum | Fri May 07 16:28:07 EDT 1999 | Andrew Wulff
On 1.27mm (0.050 inches) Standard Ball Grid Array's. The ball size diameter starts at approximately 0.025 inches. If the ball size decreases to 0.012 inches (due to the solder flowing down a via) is the solder connection reliable? This is a known L
Electronics Forum | Fri May 07 17:02:01 EDT 1999 | Earl Moon
| On 1.27mm (0.050 inches) Standard Ball Grid Array's. | The ball size diameter starts at approximately 0.025 inches. | | If the ball size decreases to 0.012 inches (due to the solder flowing down a via) is the solder connection reliable? | | This
Electronics Forum | Thu May 13 18:36:55 EDT 1999 | Andrew Wulff
| | On 1.27mm (0.050 inches) Standard Ball Grid Array's. | | The ball size diameter starts at approximately 0.025 inches. | | | | If the ball size decreases to 0.012 inches (due to the solder flowing down a via) is the solder connection reliable? |
Electronics Forum | Wed May 12 20:32:14 EDT 1999 | Earl Moon
| Earl | | you posted a message on 1-14-99 about converting to VOC free flux. Have you completed your evaluation? Could I get a copy of any data supporting your conversion to VOC free? | | Thanks | | WDR | | WDR, We are awaiting the latest dat
Electronics Forum | Mon Nov 15 14:24:17 EST 2004 | nrocco
Im looking for equipment that can attach solder balls between the size 15-25 mils to the leads of a land grid array. There is also the posibility of attaching balls before leads are inserted into the socket. This is a little differant than attaching
Electronics Forum | Wed Aug 27 08:25:24 EDT 2008 | davef
We'd expect to see: * Solder starved connections at pads with large trace/pad areas. * Less reliable solder connections at pads that do not match the shape and size of the corresponding pads on the component.
Electronics Forum | Fri Aug 22 00:20:29 EDT 2008 | rameshr
Hai, In our process we are using the micro bga of size 13X13mm of pitch 0.45mm,after soldering process the bga found collapsed, we absorbed that the PCB land pattern of the BGA was not in array, uneven distribution of pads (area) & most of the pads
Electronics Forum | Thu Dec 07 14:23:30 EST 2006 | russ
I wuld say it is attachment method and post install force that is the problem not the size of the heatsink. we place heatsinks that are at least 5 times the size of BGA with no issue, they are attached with very precision torque drivers. Russ
Electronics Forum | Wed Nov 29 00:43:45 EST 2006 | callckq
Dear all, Recently, we run 2 models with heat sink attachment on top of this BGA(on top of this BGA, there is flip chip attached at the center of the BGA). Hence, the center of the BGA is higher than corner/side. We used conventional way to attach
Electronics Forum | Fri Jun 17 23:31:12 EDT 2005 | kenscj
Hi all, currently, we are seeing BGA problem like solder ball misalign, void, solder short (all under BGA, tested with 5DX), after reflow. We examine the solder ball (raw material of BGA), and see that the ball surface is not smooth, will that affe
