Electronics Forum | Thu Jun 06 09:28:24 EDT 2002 | Hussman69
Sure do, it's from the paste that gets squeezed under your R's and C's. This paste is now on your mask and during reflow, wants to move off the mask. Unfortunatly, it follows the flux residue to the side of your component. An easy fix is to use th
Electronics Forum | Wed Nov 11 10:08:38 EST 1998 | Magnus
| | Hi, | | We are having problem with yield loss due to electrical fail. Further investigation shows that the failure is due to solder bridging under BGA. Has been there any study or experience on how this could occur and what we can do to prevent
Electronics Forum | Wed Sep 02 06:50:55 EDT 1998 | Masdi Muhammad
Hi, We are having problem with yield loss due to electrical fail. Further investigation shows that the failure is due to solder bridging under BGA. Has been there any study or experience on how this could occur and what we can do to prevent it. Than
Electronics Forum | Tue Jun 04 17:21:22 EDT 2002 | jasonfang
I found solderballs are around chip components (on one side of middle area), I checked gerber data, solder paste of aperture on the stencil for these chip components have 5% reduction to solder land on PCB, shape of solder land are square, not home p
Electronics Forum | Mon Dec 30 23:37:47 EST 2019 | agoesfirmanto
Hello All, I am a SMT Engineer from Indonesia, I am facing the problem of soldering balls in only one IC location, in other areas there are none. solder ball defect almost 30%. I have done several actions but failed to reduce the solder ball. 1.
Electronics Forum | Tue Jun 04 20:34:28 EDT 2002 | russ
Jason, Excessive thermal ramp rates, misprints, improper pad design, paste type, placement pressure, all can cause solderballs. Do the pads on this board meet IPC 782 criterias? I have found that too much pad underneath component can cause this. A
Electronics Forum | Thu Jan 02 10:31:48 EST 2020 | slthomas
It is strange that you're having issues while using the same process parameters (including stencil) that worked successfully before. It doesn't guarantee that it's not one of those parameters changing in a manner that's not apparent, but it does sugg
Electronics Forum | Thu Aug 24 15:37:50 EDT 2006 | Chunks
Hi Any, This is from an earlies thread "Solder Ball After Reflow Process". Date: August 16, 2006 01:52 PM Author: Russ Subject: Solder Ball After Reflow Process Oven settings are meaningless here. What does the board see? It is the paste we a
Electronics Forum | Wed Sep 02 08:44:50 EDT 1998 | Kelly Morris
| Hi, | We are having problem with yield loss due to electrical fail. Further investigation shows that the failure is due to solder bridging under BGA. Has been there any study or experience on how this could occur and what we can do to prevent it.
Electronics Forum | Mon Aug 29 11:05:10 EDT 2005 | foresiteeric
davef: I am a colleague of Sara at Foresite and we came to the conclusion that the solder balls were entrapped based on the minimal amount of information from the original question and the fact that the x-ray showed the balls and it wasn't mentioned
.png)
