Electronics Forum | Tue Jul 29 12:51:40 EDT 2008 | grics
I am having some problems with some of my pcbs at ive solder. We are using an ersa versaflow. It has an automated spot/spray fluxer (Interflux Pacific 2009M) , 1 preheat stage, a leaded pot/nozzel, and finally a lead-free pot/nozzel. Nozzels move, b
Electronics Forum | Wed Feb 23 17:24:06 EST 2005 | Austinj
Solder spattering, solder balls, components "popping" off pads........ Not a serious chemical reaction, however, as replied to by KEN on 12/21/04 in a similar article: "Are you adding liquid flux? Or paste "Gel" flux? If liquid flux: This, in my m
Electronics Forum | Tue Apr 13 14:14:59 EDT 2004 | russ
I have actually printed this same condition with type 3 paste Alpha WS709. I posted this for discussion and cannot remember what I called it. We did need to clean the stencil after every three prints. I did not check volume on these locations but
Electronics Forum | Tue Nov 17 03:04:38 EST 1998 | Charles Stringer
For some as yet unkown reason, we have started to have some boards sag and go under the wave. The boards are surface mount top side and conventional components wave soldered. We have checked the wave hight and both the profiles on the wave solder and
Electronics Forum | Thu Jul 27 12:09:41 EDT 2000 | JohnW
Jason, where on the board is your connector?, front / back / middle? and where it on the PCB that you don't have issues with? Thief pad's are basically dummy pad's taht you have after the last set of pin's on the component are are used to draw the
Electronics Forum | Tue Oct 31 14:52:25 EST 2000 | Dr. Kantesh Doss
Hi Antonio: You clearly have printed excessive amount of solder paste on the pad. You can reduce the amount of paste by one or two methods: 1. Switchover to 5 mil thick stencils. 2. Change the design of your stencil openings (at the discrete compone
Electronics Forum | Thu Mar 22 17:38:44 EST 2001 | davef
OK, lemme take a different angle on this, �cuz I forgot to touch on this when I first responded. I mentioned a study ["Evaluation of Low Residue Soldering for Military and Commercial Applications: A Report from the Low-Residue Soldering Task Force"
Electronics Forum | Tue Feb 19 19:36:21 EST 2002 | davef
You weren�t clear but I assume the problem is not widely distributed and affects only a few parts on each board. Do this trick: * Cut a ~1� piece of fairly serious wire, like 18 or 12 AWG. * Strip the insulation. * Gear-up with gloves, glasses, and
Electronics Forum | Mon Oct 11 13:05:51 EDT 1999 | Dave F
| | Folk's, | | | | I'm just tying up some loose end's on my Master's Thesis on solderballing @ wave soldering and the effect the topography of the mask / PCB has on it. | | I was wanting to do a straw poll on you guy's as to the type of resist's yo
Electronics Forum | Mon Oct 11 12:24:07 EDT 1999 | John Thorup
| | Folk's, | | | | I'm just tying up some loose end's on my Master's Thesis on solderballing @ wave soldering and the effect the topography of the mask / PCB has on it. | | I was wanting to do a straw poll on you guy's as to the type of resist's yo
winsouce.jpg)
