Electronics Forum | Sat Jan 08 11:12:49 EST 2000 | S. Evers
Hi all, Best Thing Since Sliced Bread? No doubt many of you have seen Phil Zarrow's "over-the-top" review in Circuits Assembly of the new Ersa scope, a device that allows viewing a really neat close up a side view of the component substrate interface
Electronics Forum | Tue Jul 19 08:26:46 EDT 2016 | pavel_murtishev
Aleksander, The answer is no. Solder deposit being printed is 80um-150um in height depending on PCB design what is two times higher than any track covered by solder mask. Molten solder will merely center the component. QFNs are prone to soldering
Electronics Forum | Mon Jul 18 12:24:53 EDT 2016 | oleksz
Some people involved in PCB assembly process claim that SMD components reflow soldering problems are often caused by traces running under a component. According to this claim, trace (or any copper) covered by solder mask and placed under SMD componen
Electronics Forum | Mon Jul 18 12:25:30 EDT 2016 | oleksz
Some people involved in PCB assembly process claim that SMD components reflow soldering problems are often caused by traces running under a component. According to this claim, trace (or any copper) covered by solder mask and placed under SMD componen
Electronics Forum | Tue Jul 19 11:52:24 EDT 2016 | oleksz
Thank you Pavel. Aleksander
Electronics Forum | Wed Jun 07 10:56:38 EDT 2006 | Chunks
In the past, I would normally tell out highly talented inspectors to leave the balls there. The were trapped in the flux residue and were hard to remove. Never caused a problem. But then there was an incident where someone had the bright idea to u
Electronics Forum | Fri May 17 16:53:50 EDT 2002 | davef
I recall a couple of papers in the SMTA 'Knowledgebase' that used ball shearing and an element in a study that compared BGA [maybe uBGA] component fabrication methods, er sumpin.
Electronics Forum | Fri Feb 11 08:24:51 EST 2000 | Masdi
Hi, Need help. We are starting to see a lot of small solder under capacitors and some of them can be bigger than 10 mils. For current action, we have checked through screen print process and component placement but still don't have any clue on how
Electronics Forum | Thu Nov 30 08:09:19 EST 2006 | INGE
Hi everybody, The matter is this: after reflow, on top side leads of chip components (resistor 0805)appear some empty balls of solder. In some cases this thing is only on the lead and the solder joint seems good, in other cases this empty ball is als
Electronics Forum | Sat Dec 30 04:23:50 EST 2023 | 012band
I have used LTS (Sn57.6%Bi0.4%Ag) solder balls for soldering on Ni/Au pads, and I have observed a wrinkle pattern on the ball surface. When you attempted soldering on CuOSP substrate pads under the same conditions, the surface appeared normal. Additi
