Electronics Forum | Mon Jul 16 19:27:27 EDT 2001 | eliishee
I have no choice, as per customer's request to remove the solder balls. Can i use water to clean away the solder ball since i'm using RMA solder paste not the water soluable paste.
Electronics Forum | Mon Jul 16 19:36:09 EDT 2001 | steven
I hv no choice as per customer's request to remove the solder balls. Can i just use water to clean away the solder balls since i'm using RMA solder paste and not the water soluable paste?
Electronics Forum | Thu Jul 05 07:34:57 EDT 2001 | steven
what is the main reasons that casuing solder ball during reflow? and how to remove them? (mostly arround the connector leads or between the 2 0402 chips). solder paste is RMA type. need advise. thanks
Electronics Forum | Fri Jul 06 04:02:28 EDT 2001 | eliishee
Thanks guys for all the input. i'm still struggling to find out the main cause. at time being, urgently need a suggestion of a effective way to remove all these solder balls. THANKS AGAIN.
Electronics Forum | Mon Jul 16 15:49:33 EDT 2001 | Steve
The solder balls you are talking about are caused by too much paste. Reduce the size of the stencil aperatures. Concerning removing the solder balls, the first thing you need to ask yourself is, do I need to remove them. IPC-610, 12.4.10 states, "Ac
Electronics Forum | Tue Jul 17 15:13:53 EDT 2001 | mparker
Dave - I agree that the U shape for QFP's sounds a bit whacked, for the reasons you state. It may work OK for larger pitchs but then again there are a myriad of fixes that work before resorting to U shapes. With the U shape removing paste from under
Electronics Forum | Mon Jul 16 21:29:03 EDT 2001 | davef
Cleaning RMA with water is bad news. It will turn your solder connections white and remove none of the RMA residues. There was a thread on removing RMA within the past two weeks on SMTnet. Check the fine SMTnet Archives. Additionally, look at M
Electronics Forum | Thu Jul 19 08:00:03 EDT 2001 | doctord
Solder balls or mid chip beads? Remember IPC classification for Class 2 allows mid chip beads encapsulated in flux. Usually on R's and C's first thing I would do is verify .006 laser stencil 10% reduction and the most critical, The paste must be on t
Electronics Forum | Wed Sep 16 15:12:08 EDT 2009 | squid
hi i have just brought a hot air rework station to remove a gpu on xbox 360 i have removed the chip but three of the pads have gone a brownish color and seem like solder will not stick to them ,does this mean the chip is ruined ? ,if so is it becaus
Electronics Forum | Mon Sep 30 09:00:26 EDT 2002 | arcandspark
Russ, I have been reworking BGA's for over five years now and have never been able to remove voids in the solder balls without removing the BGA itself. Your thermal profile can also cause the voids along with a poor solder paste. I have experimented
