Electronics Forum | Fri May 01 22:05:23 EDT 1998 | D.Lange
| I've never seen this before. Today, I got this tombstoning on Tantalum Capacitors (Okay, I saw that before) | Here's the part that seems weird to me: | -They didn't tombstone onto a termination - they went onto their sides! That's right, both ter
Electronics Forum | Thu Oct 16 11:15:53 EDT 2008 | davef
A good solder connection with heavy ground plane requires: * Plenty of heat [Is the preheater located too far from the wave? Whenever you look at board temperature, there is a sharp decrease in temperature between the preheater and the wave.] * Conta
Electronics Forum | Wed Jun 02 15:27:27 EDT 1999 | JohnW
| | Hi, | | | | To improve the Design For Manufacturing I am currently looking to write down some design rules that can (and should be) used by our engineering department. | | | | Can somebody help me get started or give some usefull tips on where
Electronics Forum | Mon May 11 17:35:01 EDT 1998 | Steve Gregory
On 11 May, 1998 Todd wrote: | We are having continuous bridging problems with the trailing | leads on a 26-pin D-sub through-hole connector. The pitch is | 0.100". The connector is going through the wave at approximately | a 20 Degree angle. Does
Electronics Forum | Thu Mar 09 20:48:30 EST 2000 | Dave F
Van Hoang: Welcome to SMTnet!!!! Regarding your problems: 1. Cleaning glue: Check the SMTnet archives. For instance, a recent thread was: cleaning glue off of stencils - pr 13:41:43 03/03/2000 2. Bridging on the wave: Bridging on the wave h
Electronics Forum | Thu Mar 09 20:48:30 EST 2000 | Dave F
Van Hoang: Welcome to SMTnet!!!! Regarding your problems: 1. Cleaning glue: Check the SMTnet archives. For instance, a recent thread was: cleaning glue off of stencils - pr 13:41:43 03/03/2000 2. Bridging on the wave: Bridging on the wave h
Electronics Forum | Tue Jan 28 16:27:43 EST 2003 | MikeF
I agree with most of the other suggestions here, but 90 C for a topside preheat temp seems low to me. I remember aiming for 98 to 104 C for topside temp just before hitting the solder. Boards that had large ground/power planes or a lot of layers I wo
Electronics Forum | Thu Jul 13 22:20:38 EDT 2000 | Dave F
=10 mils larger than lead 3 silk screen legend text weight >=10 mils 4 pads >=15 mils larger than finished hole sizes 5 place through hole components on 50 mil grid 6 no silk screen legend text over vias (if vias not solder masked) or holes 7 so
Electronics Forum | Wed Dec 22 14:21:13 EST 2004 | James Dornan of APE Inc
A little late but if this subject is still of interest the following paper from APE may be of interestwhen considering IR to Air Bath: HOT AIR versus IR and other convection Rework Systems HOT AIR is the most popularly chosen method of rework in th
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
winsouce.jpg)
