Electronics Forum | Fri Jul 04 21:09:04 EDT 2003 | ramanandkini
I have a CEM-1 PCB board with 35 microns copper. This is PCB is finished with SMOBC+HALS. We do solder SMT LEDs, but till date we do not have problems that you have listed. The LEDs are good & bright. It even passed high & low temp cycle tests (-40 t
Electronics Forum | Mon Apr 12 22:22:01 EDT 2004 | davef
Large voids are common in via in pad [seach the fine SMTnet Archives for earlier laments], especially in blind via. Observations on your via out gassing theory: * If the copper plating on your via is GT 1 thou, there will be no outgassing from the
Electronics Forum | Tue May 26 17:29:42 EDT 1998 | Earl Moon
| I know, I've read the "been there done that" stories about this subject, but I still profess ignorance on some aspects. | We are using NPO type dialectric caps in potted high voltage assemblies and continue to experience catastrophic vailures. U
Electronics Forum | Tue Apr 27 16:21:09 EDT 1999 | Chrys Shea
| Another basic soldering question. I notice that lead-free solders have become required for plumbing applications due to legislation. In a local hardware store, I noticed the existence of lead-free solders (based upon tin-copper I think) with a me
| 1 |
