Electronics Forum | Tue Mar 18 07:53:39 EST 2003 | Paul Staniford
I am looking at dispensing solder paste using a Fuji GLV glue dispenser. This is to enable us to produce prototype pcb's without the need to purchase a stencil. Has anybody tried this before? If so what problems should I expect to encounter.
Electronics Forum | Tue Mar 18 09:09:37 EST 2003 | pjc
The FGLV has a air pressure displacement valve, which is designed for adhesives. A positive displacement valve is better suited for solder pastes. Check with Fuji to see if they offer optional valves.
Electronics Forum | Tue Nov 22 19:32:27 EST 2011 | kenkay
We are looking for a new machine to replace our Asymtek C-708 that we use for wave masking. Asymtek offers a D-585 but we were looking for something better then a table top unit. Any recommendations on a company or machine? Thanks
Electronics Forum | Wed Nov 23 16:53:09 EST 2011 | davef
There's a lot of excellent dispenser suppliers out there that will willingly claw their competitors' eyes out to get your business. Note: Camalot Essemtec Asymtek (Nordson) Precision Valve Creative Automation GPD IJ Fisnar Janome Fuji NE3000S fuji
Electronics Forum | Wed Jan 30 09:37:28 EST 2002 | clarkk
Does anyone out there have experience dispensing solder paste with a Universal GDM (4716AL) with positive displacement pumps? I'd like to hear any comments on the success or failure of the machine to dispense consistently, effect of temperature varia
Electronics Forum | Tue Mar 18 09:11:14 EST 2003 | Rob C
With a standard valve and no-clean solder paste you may get a few good dots. But, repeatability will be terrible too many variable, air-pressure, board height (two post nozzle), valve time on/off, retract height, retract time, etc... A RMA paste wi
Electronics Forum | Fri Jul 09 11:19:58 EDT 1999 | Carol Brumfield
Has anybody successfully used an automated dispensing system to put solder paste dots on .5 mm pitch pads?? I need to replace some Meritec tsop sockets and I don't want to use the single site stencils for .5 mm parts.
Electronics Forum | Thu Jul 29 21:12:55 EDT 2004 | davef
Use a spray fluxer, like those used in wave soldering. Search the fine SMTnet Archives for supplier names. We understand that spray fluxing is significantly different than dispensing. What do you want/expect to accomplish by dispensing liquid flux
Electronics Forum | Wed Jul 28 11:47:16 EDT 2004 | GCronin
I am looking for a consistent method of applying no clean liquid flux to solder pads. My main concern is if I use a standard air-over type dispenser mounted to an automated arm that the liquid flux will make a mess and not be consistent. I'm not to
Electronics Forum | Sat Jul 10 12:18:10 EDT 1999 | Steve
| Has anybody successfully used an automated dispensing system to put solder paste dots on .5 mm pitch pads?? I need to replace some Meritec tsop sockets and I don't want to use the single site stencils for .5 mm parts. | Try http://www.winslowaut
