Electronics Forum | Tue Jul 06 12:21:38 EDT 1999 | Kelly Morris
I've heard that use of VOC free flux with wavesolder fixtures can be challenging due to entrapment of water in the fixture. Is anyone out there successfully running VOC free with wave fixtures & did you experience problems? If so, how did you resol
Electronics Forum | Tue Jul 06 12:45:28 EDT 1999 | JohnW
| I've heard that use of VOC free flux with wavesolder fixtures can be challenging due to entrapment of water in the fixture. | | Is anyone out there successfully running VOC free with wave fixtures & did you experience problems? If so, how did you
Electronics Forum | Tue Jul 06 13:02:41 EDT 1999 | John Thorup
| | I've heard that use of VOC free flux with wavesolder fixtures can be challenging due to entrapment of water in the fixture. | | | | Is anyone out there successfully running VOC free with wave fixtures & did you experience problems? If so, how d
Electronics Forum | Tue Jul 06 14:23:27 EDT 1999 | Earl Moon
| | | I've heard that use of VOC free flux with wavesolder fixtures can be challenging due to entrapment of water in the fixture. | | | | | | Is anyone out there successfully running VOC free with wave fixtures & did you experience problems? If so,
Electronics Forum | Mon Nov 26 12:00:20 EST 2001 | peterson
Hi everyone, I am looking for a reliable company (preferrably on the west coast) that can make Wave Solder and Press-Fit fixtures for our back-plane division. I need a reliable source that can take our data and produce quality fixtures in a 5-7 day
Electronics Forum | Thu Nov 13 09:27:21 EST 2008 | cisridn
I have tried covering the vias with thermal tape and that did not work. I like the idea of plugging the via with a temporary solder mask. I will try that the next time I build a fixture which should be tomorrow. This is mainly a problem only becau
Electronics Forum | Fri Nov 14 17:21:17 EST 2008 | cisridn
Plugging the holes with temporary solder mask helped some, but once the solder starts to reflow, the fumes from the flux pushed the solder mask out. What I ended up doing in addition to using the temporary solder mask was covering the areas of pcb w
Electronics Forum | Wed Nov 12 13:00:58 EST 2008 | cisridn
I have to build test fixtures for RF Power transistors. These components generate alot of heat so the PCB is soldered to a baseplate. The problem I am having is that I am getting too much solder flowing thru the via's and flooding the topside of th
Electronics Forum | Wed Nov 12 22:34:30 EST 2008 | davef
How about plugging the via with a temporary solder mask or coving them with thermal tape?
Electronics Forum | Wed Dec 10 21:40:06 EST 2008 | davef
So, this fine designer thinks the cost of you putzing around with is thing is cheaper to the comapny? No. The fine designer is measured on in-bound cost, but not on the impact on overhead of those in-bound costs. OK, try this one: Have your fabric
.gif)
