Electronics Forum | Mon Jun 19 19:08:21 EDT 2000 | Brian W.
IPC-610 Rev B: Paragraph 4.1 (page 52), As an exception to fil requirements on Table 4-1 on thermal heat sink planes plated through holes, a 50% vertical fill of solder is permitted, but with solder extending 360 degrees around the lead with 100% wet
Electronics Forum | Sat Jun 17 08:57:23 EDT 2000 | Chrys Shea
A few more tricks to try: - Got a hot air rework machine? You can get more controlled heat on the area and lower the risk of damage to the fab. I never got topside fillets un unrelieve ground planes until I went to convection preheat on my waves.
Electronics Forum | Mon Dec 30 23:37:47 EST 2019 | agoesfirmanto
Hello All, I am a SMT Engineer from Indonesia, I am facing the problem of soldering balls in only one IC location, in other areas there are none. solder ball defect almost 30%. I have done several actions but failed to reduce the solder ball. 1.
Electronics Forum | Thu Jun 10 19:20:59 EDT 2021 | kojotssss
Hi, Too much paste on grounding pad. Looks like also doesnt have path for gases, for void escaping.
Electronics Forum | Wed Feb 05 15:16:15 EST 2003 | davef
If the voiding is not related to entrapped air in your vias, consider trying a different paste.
Electronics Forum | Fri Feb 07 11:58:47 EST 2003 | dphilbrick
We went to Indium WS to help reduce this type of issuse as well might want to think about a cross through the middle this has also helped us on similar issues.
Electronics Forum | Thu Nov 30 16:14:33 EST 2006 | darby
Maybe ask your customer where they got this idea from? It is possible they may have even got this idea from some white paper or article where they are trying to explain something else and show drawings with no solder between the pad and lead. It may
Electronics Forum | Thu Apr 07 09:26:03 EDT 2011 | alcatel
Im trying to get the XY data to program the SMT machines. since i dont have the file, im trying to convert it from the gerber drawing. the closest one to represent the component placement is the solder pad. ive tried using linkcad to convert it to XY
Electronics Forum | Fri Nov 09 16:58:30 EST 2001 | davef
Go for it!!! You were unspecific, but adding mask to a completed board could cause: * Increased paste thickness, if you have double thickness of solder mask. * Wrinkled and lifted solder mask under the component, if the solderability protection of
Electronics Forum | Tue Nov 28 09:21:58 EST 2006 | Michael Sanders
Is anyone aware of any articles, white papers, etc., that discuss the gap between the lead and the pad after a SM joint is soldered? In particular, I am looking for a formula for that "gap" for various components.
.gif)
.png)
