Electronics Forum | Fri Sep 01 03:06:20 EDT 2000 | Adelina Baggayan
Hi!, Can anyone help me with problems with Solder voids after reflow curing on D2PAK heatsinks? I would like to remove the gas from the solder paste; can centrifuge help?How many minutes should a solder paste in a tube be processed in a softener? Ho
Electronics Forum | Mon Jan 07 20:31:15 EST 2002 | davef
While not a Motorola 860 BGA user, we see that on other components. In fact, some of the ErsaScope adverts show the effect. WHAT CAUSES THIS? Generally, the design / layout of the interposer has been the cause of this appearance. IS THIS A CONCER
Electronics Forum | Wed Jan 15 10:31:55 EST 2020 | emeto
Having 10c thermal differential is a lot. Trying different paste might help - usually thermal expansion makes component detach from PCB, then joint is formed and solidified, then component goes back but is too late to form a joint. Cooling speed migh
Electronics Forum | Wed Jan 15 11:18:51 EST 2020 | avillaro2020
Hi Evtimov, Thanks again! The solder wicking/open solder joint is not actually gross rejection, it is only a few and appeared random (difficult to trend the location of the opens), what is perflexing is that i have this 1 or 2 open solder joints sur
Electronics Forum | Mon Feb 06 09:17:35 EST 2006 | Cal Kolokoy
Mike did you have these SEM'd to be able to see the IMC's within the solder joint?
Electronics Forum | Thu Oct 05 11:48:00 EDT 2006 | Mario Scalzo, SMT CPE
Good morning all. We are able to offer some insight into the problem and offer a recommended reflow profile to solve this issue, but it really depends on the solder paste that you use, as different manufacturers use different boiling point solvents.
Electronics Forum | Thu Nov 08 10:52:22 EST 2012 | Bryan Ng
I am considering using high-temp ball Sn10Pb90 + eutectic solder paste for MLC reflow (no underfill). You can see that there is no Intermetallic bond for the paste and the balls. Under high stress/shock condition, the solder joints develop micro c
Electronics Forum | Tue Jan 14 17:22:16 EST 2020 | emeto
Avillaro, would you say that vapor phase process was selected, because the boards are so thick and heavy? I would assume so. Have you ever tried to run them through reflow oven? To understand better your challenge, we need to understand the setup be
Electronics Forum | Mon Jan 13 17:39:49 EST 2020 | avillaro2020
Hi, I need help on how to address the solder wicking on the samtec searay connector after reflow resulting to open solder joints on thick and thermal heavy PCB (4.4mm and 6.3mm). I increased my solder paste thickness to 8 mils, the connector is manua
Electronics Forum | Fri Feb 03 16:40:24 EST 2006 | Mike
At my last employer, we ran a number of tests to make a "Hybrid" profile work (same profile Joe lists) . It worked great for everything but BGAs. The problem (6 months ago) was using parts not rated for lead free reflow temps. As the market fills wit
