Electronics Forum | Thu Jun 28 17:05:46 EDT 2012 | davef
Here’s what we seem to know: * There’s a problem with voiding in the solder connections of SMT capacitors * A void is an open area caused by air or process fluid that is trapped within a solder connection * Voids are an allowable condition as long as
Electronics Forum | Wed Apr 06 12:36:53 EDT 2005 | smt_rookie
I've tried a different lot of the same double header connector (yes its double level right angled header conector) twice but nothing has improved. I've also suspected that top row of the connector has greater heat sinking capacity (which should hold
Electronics Forum | Thu Apr 19 02:49:07 EDT 2007 | ray
I observed some black dot or some oxidation occured on chip termination on pcba reflowed fews weeks ago as buffer stock. The solder joint and fillet wetting is good and shinning. It is an acceptable or defect condition per IPC standard/requirement? W
Electronics Forum | Thu Apr 20 02:44:39 EDT 2017 | tsvetan
The hole is too big, you should reduce the size in the next PCB revision. The middle joint is soldered at low temperature you can see how the solder didn't distributed evently and cooled on waves. The solder joint at the bottom didn't wet the capac
| 1 |
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
