Electronics Forum | Sun Apr 25 11:18:45 EDT 1999 | Earl Moon
| Hello all, | | Been doing some comparisons on joints made using the soldering iron versus reflowed solder paste (on a QFP package). The difference is quite significant: the joints made by the soldering iron are inconsistent and in many cases not
Electronics Forum | Wed Sep 13 12:08:02 EDT 2000 | Dave F
Charlie: I'm with Wolfgang ... The prime cause of your cracked solder joint on a surface mount part is mechanical stress. That�s about as specific as you�re gonna get. More information would be helpful. For instance: * Talk about the distribution
Electronics Forum | Fri Sep 22 05:33:59 EDT 2000 | Wolfgang Busko
That "C - it doesn�t matter" choice sounds good because it doesn�t give you a headache when profiling but it gives me a headache when I read the article in the current "newsletter" about profiling where I found this: "If soldering to gold over nick
Electronics Forum | Tue Aug 22 21:00:39 EDT 2006 | davef
National says: [ http://www.national.com/packaging/llp/faq.html#faq_manu ] Manufacturing FAQ's Are there any precautions that need to be taken with the LLP package? It is critical to follow National�s guidelines for successful surface moun
Electronics Forum | Fri Nov 22 15:59:43 EST 2002 | GSW
What type of reflow profile are you using ? There is a void reduction profile recommeded by some paste manufacturers, Try that it might help. Did you check the components or the board and see if they have absorbed mositure ? try baking the boards and
Electronics Forum | Wed Oct 07 15:25:02 EDT 1998 | Joe P.
Hi Everybody | | Is anyone aware of the possible causes that may lead to voids in the solder bumps after assembly. We assembled some dice on thin substrates and after assembly, void formation in the solder bumps were observed. | We have alread
Electronics Forum | Mon Dec 13 21:11:53 EST 1999 | Curtis T.
Steve, I have done countless board profiling and oven reflow profiles. Here are the critical factors on you need to address. What is your board surface finish, if it is something like an OSP it will need a good amount of an active (aqueous) flux to
Electronics Forum | Thu Nov 19 05:18:37 EST 2009 | prodivegsr
Hi All, Recently we are working on the conformal coating process using Humiseal chemical 1B73 and thinner 521. Bubbles on component body/joints are seen after gone through the IR Reflow Oven. During the conformal coating, only tiny bubbles seen af
Electronics Forum | Fri Apr 29 14:16:16 EDT 2011 | ppcbs
Below is the long explanation. This defect is most commonly found with BGA components, but can arrise with all components. I see it happening more now with lead free boards that are being assembled with a no clean flux. Best short term remedy is t
Electronics Forum | Wed Aug 10 10:41:23 EDT 2005 | patrickbruneel
Bob, Great theory if you're selling SN100C, but I have to disagree that an alloy being 4�C off eutectic will cause cracks. When a solder joint exits the solder wave, there is an immediate drop in temperature of 100�C. so being off 4�C is irrelevant.
