Electronics Forum | Wed Jul 03 03:02:35 EDT 2013 | autoel
How to test the reflow solder joint shear strength? What are the specification to test solder joint shear strength? What are the different methods to test the solder joint shear strength? Vijayashree
Electronics Forum | Wed Jul 03 15:40:17 EDT 2013 | davef
Shear tests are [in my opinion] senseless. The shear stress you measure depends more on the shear rate and on the point where the force is applied than on the grain structure. When shearing a component, you not only apply shear stress, but also roll
Electronics Forum | Tue May 23 20:39:37 EDT 2000 | Dave F
Scott: Sounds like fun: � Solder joint strength in pull/shear varies with lead geometry, solder volume, lead metal/metallization, and the test method. � Among things, IPC-TM-650 talks to getting pads off-of boards. For instance: Method 2.4.8 is for
Electronics Forum | Fri May 17 16:37:28 EDT 2002 | Tom Druan
I was wondering if anyone could direct me towards documentation on shear test methods/apparatus to test the bond integrity of a solder ball to its substrate. Thanks.
Electronics Forum | Fri May 17 16:53:50 EDT 2002 | davef
I recall a couple of papers in the SMTA 'Knowledgebase' that used ball shearing and an element in a study that compared BGA [maybe uBGA] component fabrication methods, er sumpin.
Electronics Forum | Fri Mar 30 20:06:55 EST 2001 | aortiz
Maybe there's no test and I don't know where or why my customer came with that requirement (I think because in one of the board shipments he got a board were a smd resistor broke, but I think that happened because miss handling), but anyway I need so
Electronics Forum | Fri Mar 30 13:06:50 EST 2001 | aortiz
Hi, I need support on the method or applicable standard to measure the shear force strength on chip capacitors and resistors. I know the soldered joints strength is related to land desing, solder volume, pcb and component solderability, component
Electronics Forum | Wed Mar 30 16:46:03 EST 2005 | chunks
There is no spec because solder is designed to provide an electrical connection not a mechanical connection to hold the part on. If it where mechanical we�d be welding our parts on. Your pad width and length are derived from your component manufact
Electronics Forum | Wed Oct 06 22:55:14 EDT 2004 | davef
Your customer is correct. Components should not fall a board during a reasonable drop test. A shear test poorly represents a drop test. A drop test represents a drop test very well. If you want to proceed with shear testing, search the fine SMTne
Electronics Forum | Thu Dec 09 15:19:21 EST 2004 | nrocco
Can anyone point me in the direction to find some IPC standards for lead free solder joint reliablity tests, such as shear tests, pull tests, vibe tests, enviroment tests, etc. I need to know what the specs. are on all aspects of reliability and how
.gif)
