Electronics Forum | Wed Aug 24 12:37:38 EDT 2011 | hussman
Hello all, We just got some board back from thermal shock and we found that several of the 2512 resistors opened up. Actaully the solder joint cracked away from the board. All other coponents look great. Boards were good before test. 10 layer bo
Electronics Forum | Mon Aug 24 07:16:52 EDT 1998 | Paul Horan
| | | I am looking for advice or information from anyone about the possible reliability problems associated with epoxy on solder pads of discrete devices. Will the epoxy expand and lift over time, Will there be adverse reaction between the solder and
Electronics Forum | Thu Aug 06 10:30:41 EDT 1998 | Mike
| | I am looking for advice or information from anyone about the possible reliability problems associated with epoxy on solder pads of discrete devices. Will the epoxy expand and lift over time, Will there be adverse reaction between the solder and t
Electronics Forum | Mon Aug 24 07:12:20 EDT 1998 | Paul Horan
| | | I am looking for advice or information from anyone about the possible reliability problems associated with epoxy on solder pads of discrete devices. Will the epoxy expand and lift over time, Will there be adverse reaction between the solder and
Electronics Forum | Fri Aug 07 02:32:09 EDT 1998 | P.L. Sorenson - Technical Consultant
| | | I am looking for advice or information from anyone about the possible reliability problems associated with epoxy on solder pads of discrete devices. Will the epoxy expand and lift over time, Will there be adverse reaction between the solder and
Electronics Forum | Tue Nov 13 12:25:12 EST 2007 | gradloff
I have a thick board with ground planes that will be soldered by hand with a mildly active solder/flux. X-ray confirmed that solder was added to the top of the joint causing a void between the bottom and top solder joint. Other than the mildly acti
Electronics Forum | Thu May 13 18:36:55 EDT 1999 | Andrew Wulff
| | On 1.27mm (0.050 inches) Standard Ball Grid Array's. | | The ball size diameter starts at approximately 0.025 inches. | | | | If the ball size decreases to 0.012 inches (due to the solder flowing down a via) is the solder connection reliable? |
Electronics Forum | Fri May 07 17:02:01 EDT 1999 | Earl Moon
| On 1.27mm (0.050 inches) Standard Ball Grid Array's. | The ball size diameter starts at approximately 0.025 inches. | | If the ball size decreases to 0.012 inches (due to the solder flowing down a via) is the solder connection reliable? | | This
Electronics Forum | Fri Oct 30 15:09:44 EST 1998 | ChungPark
| Dear all, | | What are your views on reworking BGA's? I mean, with the BGA going through reflow temperatures four times or more, and with a manual reballing process, wouldn't it raise up a few reliability issues? Would you consider not doing rew
Electronics Forum | Mon Oct 29 18:21:43 EST 2001 | slthomas
We recently have received a lot of warped (bowed and/or twisted behond IPC 600 specs.) bare boards (some our fabricator's fault, some ours by design) and I can't help but figure that long term reliability will suffer when building product with them.