Electronics Forum | Wed Jan 05 16:46:44 EST 2000 | Dennis O'Donnell
Several methods work well. 1. (Low Volume Method) Using an Xacto blade, scrape off the solder mask holding the blade flush being careful not to use the pointed part of the blade. 2. (High Volume Method)Tape off the area that you don't want the mas
Electronics Forum | Tue Oct 19 10:53:14 EDT 1999 | Carol Zhang
Hi, I tried to use high temperature solder (540 - 570F)to connect four spacers on the board. The solder mask around the spacers wrinkled a lot.I can even see a few bulbs around it. I use hot plate and solder rings. After hot plate is heated to appr
Electronics Forum | Thu Oct 21 23:20:05 EDT 2010 | camtechpcb
According to the Trichromatism.Half red and half blue will get purple.But the trichromatism only apply to color light. The red and blue soder mask are coloring material.Both of them absorb light.You mixed them up,so you lose blue and red,and get grap
Electronics Forum | Tue Dec 17 11:01:24 EST 2002 | Tim Marc
Hello all, One of our PCB manufacturers coated a through hole connecters vias with solder mask. The only IPC references that comes close to describing this problem is 2.9.2 Registration to holes, and subsequent specification 6.3.1 PTH � Vertical fil
Electronics Forum | Tue Oct 19 11:28:05 EDT 1999 | Brian
Carol You're asking a helluva lot if you heat a PCB to 300�C and probably more in such an uncontrolled process. I'm surprised it is not irreparably damaged or, at least, discoloured. I don't think any solder mask is designed for this temperature. W
Electronics Forum | Mon May 24 12:05:53 EDT 2010 | deanm
Did you try Techspray Wondermask W? It is water soluble and can probably be transferred from the bottle to an EFD type syringe for dispensing (we use the P and the PL that way). As far as if it will swell through the reflow, I don't know. We don't us
Electronics Forum | Tue Dec 17 17:47:49 EST 2002 | Tim Marc
Dave, I�m talking about the 75% vertical fill of solder IPC 6.3 criteria (B), and 6.3.1 Fig 6-5. I also referred to the annular ring of the Plated-Through-Hole, being coated with solder mask. Semantics, yes I did refer to the Plated-Through-Hole (Sup
Electronics Forum | Tue Oct 19 12:05:42 EDT 1999 | Wolfgang Busko
Hi Carol, does that happen also when you solder them with an iron ? That�s what I did with some joints using hightemp solderwire and couldn�t notice anything you mentioned. What Brian and Dave said should be worth considering. good luck Wolfgang
Electronics Forum | Mon Aug 09 16:15:30 EDT 1999 | JohnW
| I am having cleaning problems when processing PCB's which have | TAIYO solder mask on them. After processing, hand soldering and | cleaning, a sticky residue is remains, resulting in a cosmetically poor finish with tide marks etc. Other soldermasks