Electronics Forum | Fri Jan 09 10:06:18 EST 2009 | boardhouse
Hi Konrad, Nothing is ever Clearly one persons issue. Color differences could be caused by many things. 1) Being the solder mask is a two part mix, there is never a 100% guarantee that the color will be the same from lot to lot. 2)the Manufactur
Electronics Forum | Fri Feb 19 14:43:46 EST 1999 | Nithy
We are in the process of getting into no-clean paste and fluxes. One important issue in this is sodler balling. I have heard some people say that having a matte finish would help in having lesser solder balls and that the solder balls would not be
Electronics Forum | Mon Aug 09 04:15:33 EDT 1999 | Jacqueline Coia
I am having cleaning problems when processing PCB's which have TAIYO solder mask on them. After processing, hand soldering and cleaning, a sticky residue is remains, resulting in a cosmetically poor finish with tide marks etc. Other soldermasks do no
Electronics Forum | Sat Feb 20 09:56:22 EST 1999 | Tufty
| We are in the process of getting into no-clean paste and fluxes. One important issue in this is sodler balling. I have heard some people say that having a matte finish would help in having lesser solder balls and that the solder balls would not b
Electronics Forum | Wed Jan 05 14:45:14 EST 2000 | Hoyt Moore
Does anybody know how to remove solder mask from pads that were masked over.
Electronics Forum | Fri May 21 09:48:30 EDT 2010 | tomg_fla
Am looking for a dispensable water soluble solder mask or peelable solder mask that can be dispensed and be run through a reflow oven with no swelling or degradation. Any leads on any materials or manufacturers to contact?
Electronics Forum | Wed Dec 18 08:38:17 EST 2002 | davef
Thanks Tim. Additional thoughts are: * We've talked here on SMTnet about hole fill previously. * That your ability to get hole fill is probably limited by mask in the hole makes us very uneasy, because hole could have varying levels of solder mask i
Electronics Forum | Wed Dec 11 11:35:15 EST 2019 | dilogic
Just out of curiosity - what is the rationale behind specifying mask thicknes?
Electronics Forum | Wed Dec 11 13:00:07 EST 2019 | slthomas
Excessive mask thickness also can wreak havoc on stencil printing.
Electronics Forum | Wed Oct 13 12:07:43 EDT 1999 | mikeh
Hi, I am currently using a peelable mask prior to wave soldering and have started exploring water soluble/washable masks. The mask will be used with water based and alcohol based flux. Are there any compatability issues to concider and how will this