Electronics Forum | Wed Nov 20 01:38:53 EST 2019 | ajspec
Hi, i'm facing solder mask peel off but limited to the solder defined pad only(opening area). no peel off on the other area and it happened on electroless nickel immersion gold finishing only. for other finishing is not affected. kindly advise if you
Electronics Forum | Wed Dec 11 11:26:25 EST 2019 | SMTA-Norah
Yes, a polite complaint to our board shop later and the next batch didn't have that problem at least. I'm not convinced it's an ENIG issue as there was variability panel to panel in the first place.
Electronics Forum | Wed Jun 23 13:34:29 EDT 2004 | df_indy
I am four weeks into my new job, there always seems to be some issues here with PCB every week. Today while I was checking some assemblies with micro-scope, I found a lot of tiny bubbles/blisters on the board. They are just little dots if you look
Electronics Forum | Thu Jul 10 12:56:46 EDT 2014 | clydestrum
VERY interesting. Thanks, folks. I will look into this.
Electronics Forum | Fri Jul 04 06:49:41 EDT 2014 | padawanlinuxero
Hi We had the same problem but it turns out the problem is with the supplier we use a water base flux too, supplier change the solder mask and it work. cheers!
Electronics Forum | Sun Jun 29 07:31:03 EDT 2014 | vitrost
Hi, We had experienced very similar issue on boards of a certain PCB manufacturer. Field experiments showed that the solder mask of this manufacturer is prone to swelling and peeling after it was in contact with our water-based flux. When you switc
Electronics Forum | Wed Jun 04 11:09:06 EDT 2014 | clydestrum
Ok, I have an issue that is somewhat uniform in it's recurrence in that it keeps showing up on the same location on the board. The problem area is a group of traces on the exposed side, that keeps having solder mask peel occur. As you can see in the
Electronics Forum | Wed Oct 13 14:27:08 EDT 1999 | mikeh
Dave F, We are currently using a latex based ambient/thermal cure material that is applied by hand or automated dispensing equipment. Printing is an option for us, but we have not had much luck with this particular material. The mask is peeled off a
Electronics Forum | Thu Aug 18 13:11:39 EDT 2005 | jsloot
We have our board house apply a peel coat mask that can be brushed off after wave or reflow. You need to brush off while it's still warm.
Electronics Forum | Wed Jan 05 16:46:44 EST 2000 | Dennis O'Donnell
Several methods work well. 1. (Low Volume Method) Using an Xacto blade, scrape off the solder mask holding the blade flush being careful not to use the pointed part of the blade. 2. (High Volume Method)Tape off the area that you don't want the mas
