Electronics Forum | Mon Nov 12 16:12:55 EST 2001 | davef
Years ago, we used a specialty-marking pen like you describe. The pen has: * �Fluxmarker 6135 W BELMONT CHICAGO IL 60634 / 1-312-889-8323 Illinois / All other states Toll Free 1-800-621-0080 bla bla bla � marked on the barrel. A quick search with G
Electronics Forum | Mon Aug 09 04:15:33 EDT 1999 | Jacqueline Coia
I am having cleaning problems when processing PCB's which have TAIYO solder mask on them. After processing, hand soldering and cleaning, a sticky residue is remains, resulting in a cosmetically poor finish with tide marks etc. Other soldermasks do no
Electronics Forum | Mon Nov 08 15:10:52 EST 2004 | russ
We usually get some mask material from our board house. It cures with heat so it works really well in our applications. Be wary of the "overcoat pens" they don't seem to hold up under heat and thre solder will flow right underneath it during BGA a
Electronics Forum | Mon Nov 08 17:47:58 EST 2004 | davef
Russ: On "usually get some mask material from our board house. It cures with heat so it works really well in our applications.": We're unsure about the type of mask that you are using, but be careful [we used to do this, also]: * Final cure of the L
Electronics Forum | Wed Jan 05 14:45:14 EST 2000 | Hoyt Moore
Does anybody know how to remove solder mask from pads that were masked over.
Electronics Forum | Fri May 21 09:48:30 EDT 2010 | tomg_fla
Am looking for a dispensable water soluble solder mask or peelable solder mask that can be dispensed and be run through a reflow oven with no swelling or degradation. Any leads on any materials or manufacturers to contact?
Electronics Forum | Wed Dec 18 08:38:17 EST 2002 | davef
Thanks Tim. Additional thoughts are: * We've talked here on SMTnet about hole fill previously. * That your ability to get hole fill is probably limited by mask in the hole makes us very uneasy, because hole could have varying levels of solder mask i
Electronics Forum | Wed Dec 11 11:35:15 EST 2019 | dilogic
Just out of curiosity - what is the rationale behind specifying mask thicknes?
Electronics Forum | Wed Dec 11 13:00:07 EST 2019 | slthomas
Excessive mask thickness also can wreak havoc on stencil printing.
Electronics Forum | Wed Oct 13 12:07:43 EDT 1999 | mikeh
Hi, I am currently using a peelable mask prior to wave soldering and have started exploring water soluble/washable masks. The mask will be used with water based and alcohol based flux. Are there any compatability issues to concider and how will this