Electronics Forum | Mon Nov 12 16:12:55 EST 2001 | davef
Years ago, we used a specialty-marking pen like you describe. The pen has: * �Fluxmarker 6135 W BELMONT CHICAGO IL 60634 / 1-312-889-8323 Illinois / All other states Toll Free 1-800-621-0080 bla bla bla � marked on the barrel. A quick search with G
Electronics Forum | Mon Nov 08 15:10:52 EST 2004 | russ
We usually get some mask material from our board house. It cures with heat so it works really well in our applications. Be wary of the "overcoat pens" they don't seem to hold up under heat and thre solder will flow right underneath it during BGA a
Electronics Forum | Mon Nov 08 17:47:58 EST 2004 | davef
Russ: On "usually get some mask material from our board house. It cures with heat so it works really well in our applications.": We're unsure about the type of mask that you are using, but be careful [we used to do this, also]: * Final cure of the L
Electronics Forum | Thu Dec 21 13:33:46 EST 2006 | ppcbs
The problem with super glue is that is has a cyanide base that turns into a toxic gas and evaporates when heated. See IPC-7095. Via's should be fully plugged with solder mask at the fab house. If your PCB designers are not up to speed on IPC requi
Electronics Forum | Thu Dec 07 14:19:07 EST 2006 | russ
You have two options 1. Get some real solder mask form board supplier (not touchup pens) and repaint the trace and heat cure. 2. Fill the via with solder before reflowing new part, this usually works but sometimes it doesn't. We use Method 1 Russ
Electronics Forum | Tue Aug 10 20:22:15 EDT 1999 | Wayne Sanita
Hello, Could be that touchup operators are using too much flux. What are you dispensing flux with. Disposable or refillable flux pens are good to have around. | | | | hello to everybody, | | | | we have a really satisfactory no clean proc
Electronics Forum | Thu Aug 12 09:02:08 EDT 1999 | Gian.D
| Hello, | | Could be that touchup operators are using too much flux. What are you dispensing flux with. Disposable or refillable flux pens are good to have around. | |Good! could you suggest some suppliers name or address or web site or e.mail...
Electronics Forum | Mon Nov 09 09:44:22 EST 2015 | davef
Purpose. This describes setting-up a wave soldering system set-up for a new assembly design or checking a wave solder machine operation with a test board. Applicability. To be used for new design printed circuit assembles and during machine accept
| 1 |
winsouce.jpg)