Electronics Forum | Tue Dec 30 21:14:22 EST 2003 | davef
You're thinking correctly. 80Au20Sn is incompatible with: * Sn/Pb * In/Sn * Sn/Pb/In * Sn/Pb/Bi Contact your solder supplier to obtain pictures of IMC.
Electronics Forum | Tue Apr 13 13:22:15 EDT 2004 | babe
Try another solder paste manufacturer. Aim out of Rhode Island, Alpha and or Kester. I'm sure that they will be of better assistance than the current supplier. Good Luck
Electronics Forum | Mon Apr 25 10:17:22 EDT 2005 | pjc
Here's another supplier: http://www.seicatestsolutions.com/pages/24/A30-Firefly-Solder-Station.php FYI: Contax is a rep firm that sells the MTA system
Electronics Forum | Thu May 11 10:30:55 EDT 2017 | cyber_wolf
Does anyone know of a supplier that offers an "R" type solder paste ? Not "RMA" just "R" Thanks
Electronics Forum | Sat Feb 02 08:36:22 EST 2008 | davef
As a minimum, we clean the printer setup every shift change. Probably the best advice on this is from your paste supplier.
Electronics Forum | Fri Apr 29 08:39:01 EDT 2005 | davef
Few solder paste suppliers recommend freezing solder paste. Check with your supplier for recommendations. Examples are: * In many cases, nothing happens. However, some pastes are susceptible to damage that impairs paste performance. As a consequenc
Electronics Forum | Thu Apr 17 14:14:17 EDT 2003 | davef
Takfire Questions are: * Why does your customer think the capacitor is the issue? [What are we thinking? Of course the capacitor is causing this voiding problem. What else could it be?] * What are the type, construction, end-cap material and plati
Electronics Forum | Wed Feb 22 14:47:09 EST 2006 | jsloot
I have been looking at wave pallets with titanium inserts. I was told about another more recent and less expensive insert using aluminum. The aluminum is coated with some sort of material to prevent the solder from sticking. Is this anodized? Does an
Electronics Forum | Thu Feb 07 12:50:21 EST 2019 | gregcr
Hi All, What are you running for selective solder flux? I'd like any opinion on water soluble and/or no-clean fluxes you are using. In our Kiss 104 machine we use HYDRO-X20 water soluble flux, per the original install suggestion, but I'd like to k
Electronics Forum | Wed Jun 15 13:47:28 EDT 2005 | russ
No you're not stupid, they will melt if the top of the board gets real hot. I was lucky most likely in that ours were usually off of the board surface. anything that will hold the weight material will work. Now that I think about it my shot bags w
