Electronics Forum | Wed Dec 28 20:56:14 EST 2016 | anhsang38
Dear Pro, Pls, try to get solder's profile from solder supplier. That is the most important in wave soldering process... if not you will be difficult for improvement. Good luck.
Electronics Forum | Tue Dec 27 04:07:56 EST 2016 | anhsang38
Dear Pro, Pls, increase temperature up to 255ºC and considering solder's profile. Good luck
Electronics Forum | Tue Dec 27 18:29:57 EST 2016 | anhsang38
Dear pro, Could you show the solder's profile.
Electronics Forum | Tue Dec 27 10:18:03 EST 2016 | anhsang38
Dear Pro, I want to confirm with you about conveyor speed. is 1m/s? We are using wave soldering but it is 1.2m/min, min not second. Pls, check it agian. The flux is not relative this error. It is relative no sodering, bridge. The solder bar is the
Electronics Forum | Tue Dec 27 15:07:28 EST 2016 | luciano
Hello, Sorry for the mistake. The speed is 1m/min. We are using Alpha Vaculoy solder and a conveyor angle about 7º. We are not using pallets since the fingers hold the boards directly. Thanks!
Electronics Forum | Fri Dec 30 11:31:32 EST 2016 | horchak
First profilers are expensive and you can use temperature dots for setting up a wave. You stick them to the top side of the board and they change color based on temp. Top side temp should be around 250f or 125c when it hits the fountain. If you spra
Electronics Forum | Thu Dec 29 10:39:19 EST 2016 | luciano
Thanks Anshang38 I'll try and get a profiler.
Electronics Forum | Thu Dec 29 10:41:42 EST 2016 | luciano
Thanks Evtimov, The flux is brand new and the amount of flux is enough and consistent across the surface of the boards.
Electronics Forum | Mon Dec 26 14:04:42 EST 2016 | luciano
Hi all, I'm having some troubles while trying to set up a wave soldering machine that was working just fine until a few weeks ago. The wave soldering machine is quite basic chinese made. It's 2 meters long, has spray fluxing and a short preheating
Electronics Forum | Thu Dec 29 09:03:03 EST 2016 | sumote
I would cut a piece of cardboard to the same dimensions as your circuit card. Run that through the fluxer of your machine and pull it out before the pre-heater. Take a look at the cardboard and verify that flux has been sprayed on it. That board look
