Electronics Forum | Wed Aug 22 14:39:02 EDT 2012 | wendynguyen234
Our S-2000 pick & place machine has head 2 not picking up any nozzle & displays error code 8342(nozzle check error). In ANC setting, head 1 pick/put ok but not head 2; when "MANUAL" box is checked, clicking PICK/PUT then both head 1 & 2's status disp
Electronics Forum | Mon Feb 17 18:53:34 EST 2020 | richgreen01
Hi all I am experiencing z force sensor errors on a couple of different nozzles ( not hydra ) any help appreciated.
Electronics Forum | Wed Nov 20 10:21:09 EST 2013 | cyber_wolf
Station 17 and 19 errors are almost always caused by dirty clutches or bad sensor dogs. My guess would be bad sensor dogs in this case if it only does it on certain jobs. The reason it happens on those jobs is because there are nozzles being indexed
Electronics Forum | Wed Jun 01 11:02:57 EDT 2016 | claudea2
I have 3 used Quad 4Cs and the nozzle changer on one machine never worked. I decided to troubleshoot it this week. I repaired the changer by changing a defective optical sensor but I still get error 17 when I try a run-step nozzle 1, 2 or 3. Error 17
Electronics Forum | Thu Nov 08 02:09:05 EST 2018 | vinitverma
If the nozzle gets changed properly but the machine still gives the sensor, then the FNC nozzle detection sensor needs to be adjusted. It is a set of 2 sensors on a plate on the either side of the FNC. If the nozzle is not changed successfully and ge
Electronics Forum | Wed Mar 19 19:19:41 EDT 2014 | dave222
thank you for taking the time to look at this post. hopefully someone can help. I have a GSM2 Q block with a Flexjet 7 spindle head. a couple of days ago the machine encounter this issue while zeroing. the issue is with head 2 on beam 2. on the di
Electronics Forum | Thu Aug 18 12:46:43 EDT 2011 | jdengler
In the center of the head shaft there is a rod that is used to flag 2 sensors at the top of the shaft. This lets the machine know when a nozzle is attached. Check that the sensors are working correctly and the rod moves freely. The sensors are fib
Electronics Forum | Tue Feb 12 12:45:13 EST 2019 | aldrich17
Yes we do. I've done the R-axis sensor calibration multiple times in the past few weeks due to FNC Nozzle sensor errors, as well as R-axis errors. Do you suggest i go through the entire process of the Head Assembly Calibration? From section 15-1 thru
Electronics Forum | Wed Feb 13 16:27:28 EST 2019 | aldrich17
R axis is the rotation of the heads. 180 degrees and -180. The sensors tell the machine when the heads are switched correctly on the flying nozzles and the correct rotation. also i think they involve the clutch as well. After i make an adjustment to
Electronics Forum | Tue Feb 12 12:47:02 EST 2019 | slthomas
Someone with some more definitive knowledge of these machines will no doubt chime in at some point, but my thought was that the "A-table" is just a data table that stores I/O information. Thus, being "off in A-table YV100X:N2323 YV100XT:n2223" just m
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
