Electronics Forum | Wed Jan 12 19:48:41 EST 2005 | chad
Sue, What is the material your pallet is made of?? Are your thru pocket openings beveled??
Electronics Forum | Wed Jan 12 12:11:51 EST 2005 | Grant
Hi, Are you coating the bottom of the palette with flux? What's the material of the palette. I have not seen that, but we did have some weird problems when we did not add flux on a virgin palette, but once it dirtied up a little it was ok. We had
Electronics Forum | Thu May 13 10:41:39 EDT 1999 | Alberto Kaufman
I am trying to find information on soldering materials market ($),different fields soldering materials are used, prospects on market development,etc
Electronics Forum | Thu Mar 02 04:36:43 EST 2000 | ken fong
Could anyone advise the top three soldering materials providers (providing solder bars, solder paste, solder wire and flux) in each of the following regions : USA, Europe, and Japan? Thanks in advance. Regards, KenF
Electronics Forum | Thu Mar 02 04:36:43 EST 2000 | ken fong
Could anyone advise the top three soldering materials providers (providing solder bars, solder paste, solder wire and flux) in each of the following regions : USA, Europe, and Japan? Thanks in advance. Regards, KenF
Electronics Forum | Wed Jan 30 17:44:38 EST 2002 | davef
The gold is compatible with your solder. Gold will dissolve in your solder very quickly. Assuming you have a fairly large [~ couple hundred pounds] solder pot, the gold will not, over the short term, affect the performance of the pot. The issue is
Electronics Forum | Wed Jan 30 09:10:48 EST 2002 | bob_smith
Hi Dave, Sorry about that. Specifically, I am referring to radial leads on a crystal. The leads are supposed to be gold plated but only 1/2 to 2/3 of the lead is plated. We bend the lead to form a foot which is soldered to a pad on the PCB. Normally
Electronics Forum | Tue Jan 29 20:14:54 EST 2002 | davef
Please help us understand your situation better by describing the following: * Component [ie, PTH/SMT, type of component, lead finish you expected/ received, etc.] * Board type [ie, type of board FR-4/CEM/ceramic, etc.] * Solderability protection on
Electronics Forum | Tue Mar 07 22:53:59 EST 2000 | Greenman
Ken: Placings are in terms of volume or quality??...and which item? You're asking for pretty sensitive information, here!
Electronics Forum | Tue Mar 07 22:53:59 EST 2000 | Greenman
Ken: Placings are in terms of volume or quality??...and which item? You're asking for pretty sensitive information, here!
.gif)
winsouce.jpg)