Electronics Forum | Fri Dec 21 06:23:29 EST 2001 | dbrown
We are using a Sabre Max 757, supplied by Invicta UK - see http://www.invictauk.com along with Zestron SD 300. Perfect combo for paste, glue, ink etc etc
Electronics Forum | Tue Oct 29 04:40:42 EDT 2019 | jags
how long i can keep pcba after bottom reflow soldering to top side reflow soldering. like 12 hours or 24 hour or 48 hours........Enig board. leadfree soldering with 10% flux
Electronics Forum | Thu Jul 14 00:54:53 EDT 2005 | Pyramus
Hi production encountered a problem today. There have been a mix-up of solder paste. We are currently running clean process in one side of board. Unfortunately when PD run the other side process they were able to used a wrong no-clean solder paste.
Electronics Forum | Wed Oct 30 02:12:39 EDT 2019 | jags
yes and thanks for this feedback. we clean with degreaser ( strong) and flux is rosin with 10% in the paste (koki). we clean after second reflow . the gap time from bottom to topside completion is 10 hours. cleans with this time. my even after 20 h
Electronics Forum | Thu Jun 15 09:58:12 EDT 2006 | slthomas
Just to add to what dave said, the only limitation to how frequently you clean is the cost of the cleaning medium. You can wipe every board if you want to, but you'll go through material accordingly. If you're printing 16mil pitch or smaller, cleani
Electronics Forum | Sat Sep 16 03:09:35 EDT 2000 | Sartor
I am in trouble with gold finger cleaning and repairing.Can anyone recommend good solutions?Also,can anyone recommend a good flux paste source(s)?Thanks.
Electronics Forum | Fri Oct 21 14:13:08 EDT 2005 | mafc65
1.- Clean bottom and top stencil with a cloth/alcohol at same time.Pay special attention to fine pitch locations. 2.- Clean again bottom stencil side .To prevent any residual of solder 3.- Blow air with a air gun under the stencil to remove the solde
Electronics Forum | Thu Apr 11 19:12:11 EDT 2002 | djarvis
Sorry fellas -disagree. We only clean our stencils in the ultrasonic machine at the end of the run. If the same pcb is up the next day we clean them by hand. We use Electrolube SSS and the used rolls from the in line under stencil cleaner. Wipe the
Electronics Forum | Mon Nov 04 07:27:33 EST 2019 | amitthepcbguy
There are multiple methods where you can perform top and bottom reflow soldering simultaneously. With this method, you might not worry about the type of flux there is. Each part is covered and baked as per the requirement, while making sure there are
Electronics Forum | Tue Oct 11 10:49:14 EDT 2005 | jhagve
HI We start to make a product which have a 0.4 mm pitch IC and start having problems with not enough solder printed, to solve this problem we had to increase the manual cleaning, now we are cleaning the stencil every 8 printings, before we was runnin