Electronics Forum | Tue Apr 12 08:00:11 EDT 2005 | mmjm_1099
Check this site and if any questions give service a call. http://www.amtechinc.com/
Electronics Forum | Fri Dec 11 09:51:56 EST 2009 | dyoungquist
I won't say never but very rarely do we have problems with the flux seperating. The way we get around the 1-2 hour warmup time is this: The day before we run a particular job, the last person takes out the paste needed from the fridge as the last t
Electronics Forum | Thu Dec 10 12:57:25 EST 2009 | scottp
We've used mostly cartridges for many years and I only saw separation once when a particular paste supplier had a problem. With cartridges it's just thaw and use - no mixing. We have some sites that use jars along with mixers and I've never been co
Electronics Forum | Wed Dec 09 03:34:06 EST 2009 | cunningham
Sorry i wasnt very clear we already have a Malcolm sps-1 for our tubs but to move over to cartridges we need a machine to do that none of those machines are capable of mixing a 6 oz cartridge
Electronics Forum | Wed Jul 27 10:07:16 EDT 2011 | swag
We bought air dispenser guns that fit the cartriges. I can't remember where we got them - sorry. We built little aluminum "holsters" for the sides of the machines to put the guns in. The guns are hooked up to air with low pressure regulators. Wor
Electronics Forum | Thu Jul 28 07:23:24 EDT 2011 | scottp
My group supports a couple hundred lines all over the world. Most of them use squeegees but a few use either the MPM Rheometric pump heads or the DEK Proflow heads. I absolutely hate the enclosed heads. Flux separation, compaction, and the print q
Electronics Forum | Tue Jan 25 13:06:47 EST 2000 | Bill Schreiber
When switching from cleaning RMA to a no-clean flux, one area that is commonly overlooked is the stencil cleaning operation. Stencil cleaners that are effective in cleaning RMA often fail when cleaning no-clean (especially alcohol cleaners). Pallet
Electronics Forum | Wed Jul 11 18:42:35 EDT 2001 | Darby
As I mentioned in the previous string we are happy with Electrolube "SSS". The guy who built our ulrasonic cleaners recommended it and it works very well. You don't have to change tanks or machines for a switch from paste to adhesive. It doesn't leav
Electronics Forum | Tue Jul 10 18:03:49 EDT 2001 | pzohbon
Does anyone have a recommendation for a cleaning solution used in an ultrasonic cleaner for cleaning RMA solder paste off stencils and adhesive off pcb boards. I am going to be evaluating Armakleen 2001, Zestron Vigon SC 200, and Aqueous Technologies
Electronics Forum | Wed Aug 10 07:55:21 EDT 2005 | ajaydoshi
we are using heareous F381, F352 no clean solder paste. specially in qfp for high frequency board we observe that cleaing / removing of ' no clean flux 'is require. if we do not clean same most of time after all test & envioumental test it shows pin
