Electronics Forum | Fri Jan 28 09:05:35 EST 2011 | ldavis
Use tape and reeled solder preforms and place them where ever you need more solder volume.
Electronics Forum | Mon Dec 17 09:38:27 EST 2012 | cyber_wolf
Why scrap paste if there is no degradation of performance? Do your own study to determine this.
Electronics Forum | Tue Jul 16 08:39:05 EDT 2013 | cyber_wolf
The screwdriver can scrape pieces of the plastic jar off and contaminate the paste if you aren't careful.
Electronics Forum | Thu May 14 08:17:00 EDT 2015 | emeto
I am pretty sure that will vary on the paste manufacturer. Using different amount and composition of flux will give you some different viscosity. I evaluated different solder paste brands before and I can tell you that some of them are very runny com
Electronics Forum | Sat Dec 15 06:34:54 EST 2012 | sowmya
Normally paste manufacturer specifies stencil life of a paste is 10 hours. the question is, if i run a continuous manufacturing for 40 hours, we will be adding 250 g of paste for every two hours. The addition of 250 g will be mixed with the paste whi
Electronics Forum | Thu Apr 26 01:14:42 EDT 2007 | JJ
Hi all, We plan to buy solder paste height measurement machine. However, not sure which is the better one..2D or 3D? As far as I know,3D is quite slow and but more accurate in term of measurement result. Pls share with me if anyone who has this e
Electronics Forum | Thu Jan 03 02:26:12 EST 2002 | arzu
Hello, I need to know the volume spread of solderpaste after screenprinting fine-pitch paste using a nickelformed screen. It is the end-result that counts , so of course the spread of metalcontent in the paste is important too. Can anyone tell me som
.gif)
