Electronics Forum | Thu Apr 26 18:03:50 EDT 2007 | dilogic
Does anybody have a practical experience with solder paste dispenser for small-scale production (prototypes, or 10-20 pcs. batches)? What ptich size is realistic? Let's say that the speed is not an issue, but the quality is. - Deni
Electronics Forum | Fri Apr 27 11:23:40 EDT 2007 | pjc
You can get reliable solderpaste dots down to 20-30mil dia. with Type 3. Accurate and repeatable dispensing machine for X-Y-Z placement of the dot is critical. Here are the leading machines: http://www.speedlinetech.com/camalot/index.aspx http://
Electronics Forum | Thu Apr 26 20:18:45 EDT 2007 | hegemon
For what it is worth, we are purchasing a dispensing system including a Robotic Arm, Positive Displacement Valve (as opposed to volumetric displacement) and Controller. We have purchased this unit for doing lead free 20 mil dots at 30 mil pitch in s
Electronics Forum | Wed Jul 27 10:07:16 EDT 2011 | swag
We bought air dispenser guns that fit the cartriges. I can't remember where we got them - sorry. We built little aluminum "holsters" for the sides of the machines to put the guns in. The guns are hooked up to air with low pressure regulators. Wor
Electronics Forum | Thu Jul 28 07:23:24 EDT 2011 | scottp
My group supports a couple hundred lines all over the world. Most of them use squeegees but a few use either the MPM Rheometric pump heads or the DEK Proflow heads. I absolutely hate the enclosed heads. Flux separation, compaction, and the print q
Electronics Forum | Wed Jul 27 09:58:05 EDT 2011 | davef
Pressure printing systems Conventional stencil printing techniques have fundamental limitations as regards paste handling: The volume of paste available for printing is limited, so frequent replenishment is necessary Paste is difficult to c
Electronics Forum | Tue Jul 18 18:08:08 EDT 2023 | davef
Vote for: JBC DPM Paste Dispenser Manual Also consider: Metcal 910-MSG Manual Syringe Gun-Kit Spoty micro-dot solder paste syringe dispenser [ https://www.tindie.com/products/avandalen/spoty-micro-dot-solder-paste-syringe-dispenser/ ]
Electronics Forum | Tue May 21 17:31:51 EDT 2013 | Maryem
Thank you for your suggestions, Is there any industrial supplier for solder paste dispensers?
Electronics Forum | Tue Jul 18 16:14:45 EDT 2023 | daniel_stanphill
I remember having seen an ad on LinkedIn or somewhere that showed a handheld pen capable of manual deposits even on 0402 and 0.4mm fine pitch pads. I have been trying to search for it today and am seeing some comparable products but nothing that look
Electronics Forum | Wed Mar 14 19:32:04 EDT 2012 | swag
You're not clear if you intend to reclaim and re-use the paste from the stencil or not. If not, then you should go to cartridges with an air gun or modify a caulking gun for dispensing paste from cartridges. The paste will last a long time.
winsouce.jpg)