Electronics Forum | Mon Aug 23 10:11:55 EDT 2010 | flipit
Hi, I have never been able to find an acceptable dispense process for dispensing small dots of solder paste. I currently have an auger screw automated dispense system and can not accomplish 0.010" dot sizes. In addition, stencil printing is much m
Electronics Forum | Tue Mar 18 07:53:39 EST 2003 | Paul Staniford
I am looking at dispensing solder paste using a Fuji GLV glue dispenser. This is to enable us to produce prototype pcb's without the need to purchase a stencil. Has anybody tried this before? If so what problems should I expect to encounter.
Electronics Forum | Tue Mar 18 09:09:37 EST 2003 | pjc
The FGLV has a air pressure displacement valve, which is designed for adhesives. A positive displacement valve is better suited for solder pastes. Check with Fuji to see if they offer optional valves.
Electronics Forum | Tue Mar 18 09:11:14 EST 2003 | Rob C
With a standard valve and no-clean solder paste you may get a few good dots. But, repeatability will be terrible too many variable, air-pressure, board height (two post nozzle), valve time on/off, retract height, retract time, etc... A RMA paste wi
Electronics Forum | Wed Jan 30 09:37:28 EST 2002 | clarkk
Does anyone out there have experience dispensing solder paste with a Universal GDM (4716AL) with positive displacement pumps? I'd like to hear any comments on the success or failure of the machine to dispense consistently, effect of temperature varia
Electronics Forum | Fri Jul 09 11:19:58 EDT 1999 | Carol Brumfield
Has anybody successfully used an automated dispensing system to put solder paste dots on .5 mm pitch pads?? I need to replace some Meritec tsop sockets and I don't want to use the single site stencils for .5 mm parts.
Electronics Forum | Sat Jul 10 12:18:10 EDT 1999 | Steve
| Has anybody successfully used an automated dispensing system to put solder paste dots on .5 mm pitch pads?? I need to replace some Meritec tsop sockets and I don't want to use the single site stencils for .5 mm parts. | Try http://www.winslowaut
Electronics Forum | Fri Jul 09 11:28:24 EDT 1999 | Earl Moon
| Has anybody successfully used an automated dispensing system to put solder paste dots on .5 mm pitch pads?? I need to replace some Meritec tsop sockets and I don't want to use the single site stencils for .5 mm parts. | Carol, Don't blame you f
Electronics Forum | Sun Jun 18 19:59:28 EDT 2023 | smtusa
Seeing this graphic has me rethinking solder paste jetting as alternative to stencil printing. It seems it's only 2-3x faster 80k points per hour vs 28k. Wouldn't it be better to get 10 time pressure dispensers vs 1 solder jet?
Electronics Forum | Mon Jun 19 07:50:03 EDT 2023 | tommy_magyar
What I would ask before actually answering your question is, what is the smallest footprint/pad which can be pressure dispensed/jet printed? Regards, Tom.
.gif)