Electronics Forum | Wed Jul 27 09:58:05 EDT 2011 | davef
Pressure printing systems Conventional stencil printing techniques have fundamental limitations as regards paste handling: The volume of paste available for printing is limited, so frequent replenishment is necessary Paste is difficult to c
Electronics Forum | Sat Jan 22 16:39:26 EST 2011 | eadthem
Your typical high mix line would consist of, Stencil printer, 1-2 foot conveyor belt, fast PNP machine (say a universal 30 spindle turret lightning head), 1-2 foot conveyor belt, large/heavy part PNP (say a universal flex jet 7 spindle or 4 Spindle),
Electronics Forum | Fri May 11 07:37:22 EDT 2007 | davef
IPC-A-610D 3 Handling Electronic Assemblies 3-1 3.1 EOS/ESD Prevention 3-2 3.1.1 Electrical Overstress (EOS) 3-3 3.1.2 Electrostatic Discharge (ESD) 3-4 3.1.3 Warning Labels 3-5 3.1.4 Protective Materials 3-6 3.2 EOS/ESD Safe Workstation/EPA 3-7 3.3
Electronics Forum | Thu Sep 15 22:23:36 EDT 2005 | davef
Use your board supplier recommendations Specific procedure or guidelines that need to be followed for handling Moisture Sensitive Devices => J-STD-020 & J-STD-033 Is there any paste height/volume requirement for a lead-free process? => You need to
Electronics Forum | Sat Nov 08 07:05:12 EST 2008 | davef
Often, your solder paste supplier provides guideline on handling their solder paste. For instance: http://www.aimsolder.com/techarticles/tech%20sheet%20paste%20handling.pdf We have no relationship, nor receive benefit from the company referenced ab
Electronics Forum | Fri Nov 07 23:40:41 EST 2008 | padawanlinuxero
I have been working on the SMT area for a while now, must of my experience is on programming and pick and place, now in my new job I have to control a complete SMT line and I have a little knowledge on working with solder paste but I like to read mor
Electronics Forum | Fri Jul 02 17:05:26 EDT 2004 | blnorman
Depends on your specific application. Can you handle lower reflow temps? Can your parts handle higher reflow temps? What environment will your assembled product have to endure? Lot of different factors come in to play when choosing the right allo
Electronics Forum | Mon Mar 27 10:26:59 EST 2006 | slthomas
It seems highly unlikely that you could actually trap enough air in your paste for it to be releasing air after you've worked it a few times unless it's not rolling properly to begin with. I suppose maybe a contaminant could be present that could b
Electronics Forum | Wed Aug 28 10:16:12 EDT 2002 | Jim M.
Sam We install a lot of die in the SMT room using same process as SMT parts.Water soluble solder paste is used for attachment of die to ceramic and boards. Biggest problem i found is the adjustment from installing the die in the bonding area. The t
Electronics Forum | Thu Dec 10 09:06:47 EST 2009 | stepheniii
Just how cold do you store your paste? And what are your solder paste reps like? Here they fall over each other giving support for their paste. And have you seen the problem with flux separation or have you only heard about it?
